Alat penukar panas adalah alat yang digunakan untuk memindahkan dalam proses perpindahan fluida dengan lain tanpa terjadi massa di dalamnya dan dapat sebagai pemanas atau pendingin. Heat exchanger banyak shell and tube terdiri dari bagian luar dalam. Bahan penelitian ini terbuat stainless steel. Pada bertujuan mengetahui efektifitas heat variasi variabel pada suhu. Jenis aliran berlawanan arah ...

A numerical investigation is performed to study the thermal-hydraulic performances of tube-on-sheet heat exchanger. Especially, this paper focused on effects structure parameters (fin angles, fin lengths, pitches, widths, and tube arc radius) characteristics The exchanger optimized structural are obtained. results reveal that main performance angle, length, pitch, width. Furthermore, decreasing...

This paper describes experimental investigations on convective heat transfer in counter flow double pipe exchanger under transverse vibration for single-phase with twisted tape insert the inner tube. Experiments were conducted inserted twist ratio from 7 to 17, amplitude 23 69 mm, frequency 20 100 Hz and Reynolds number (Re) changing 10710 21420. A maximum gain of 91% Nusselt (Nu) was obtained ...

The presence of particles in liquid-solid fluidized beds enhances the bed heat transfer, because the movement of the particles leads to an increased turbulence in the system. Moreover, the violent movement of the particles has a positive effect on fouling of the heat transfer surface. The aim of this investigation was to perform systematic measurements of bed voidage and heat transfer coeff...

Experiments were performed to study the effects of introducing vapor into a dewar where a coaxial pulse tube refrigerator was used as a liquefier in the neck of the dewar. We were concerned about how the introduction of vapor might impact the refrigeration load as the vapor barrier in the neck of the dewar is disturbed. Three experiments were performed where the input power to the cooler was he...

This paper presents experimental investigation carried out on an unmodified four stroke diesel engine running with preheated straight vegetable oil (SVO) of Karanja. The viscosity of straight karanja oil was reduced by preheating the oil up to 1600C under different load condition. The preheating was done with the help of a Shell and Tube heat exchanger equipment without using any external power...

The classical substances as Hydrochlorofluorocarbons (HCFCs) used as working fluids in the vapour compression plants have to be replaced by new substances because of their ozone depletion potential and their greenhouse effect. Carbon dioxide (CO2) is non-toxic, non-flammable, has zero ozone depletion potential and negligible global warming potential as refrigerant. Referring to a transcritical ...

INTRODUCTION The Externally Fired Combined Cycle (EFCC) is an advanced coal-fired power generation concept with a potential for higher thermal efficiency and lower cost than conventional coal-based systems. 1 The concept incorporates efficient gas turbine combined cycle technology for use with coal. Unlike "direct fired" combined cycles, the EFCC does not require any special fuel preparation. T...