in the current engineering practices, buildings are commonly designed for an effective lifetime of 50 years. this lifetime can increase the cost of buildings with short lifetimes and can reduce the safety level of buildings with large lifetimes. in this paper, a “service-life factor” has been defined. applying this factor into the nominal values of live, earthquake, wind, and snow loads, the ef...

Intracellular calcium (Ca) alternans in cardiac myocytes have been shown in many experimental studies, and the mechanisms remain incompletely understood. We recently developed a "3R theory" that links Ca sparks to whole cell Ca alternans through three critical properties: randomness of Ca sparks; recruitment of a Ca spark by neighboring Ca sparks; and refractoriness of Ca release units. In this...

Fuel cell gas turbine hybrid systems have achieved ultra-high efficiency and ultra-low emissions at small scales, but have yet to demonstrate effective dynamic responsiveness or base-load cost savings. Fuel cell systems and hybrid prototypes have not utilized controls to address thermal cycling during load following operation, and have thus been relegated to the less valuable base-load and peak...

The purpose of this study was to determine the fracture load and failure types of veneered zirconia crowns that were air-abraded on either the veneering or cementation surface. Fracture loads were determined before and after chewing simulation. Standardized Y-TZP frameworks (n = 360) for canines were fabricated and divided into one control group (n = 72) and 12 test groups (n = 24). The test gr...

OBJECTIVE To evaluate the ability of the resin-coat technique used in cavity preparation to protect dentin before impression taking and final cementation and its effect on the tensile bond strength of indirect restorations after thermal and load cycling. METHODS Occlusal enamel was removed from 25 third molars to expose flat dentin. Teeth were divided into 5 groups (n=5): G1, receiving no den...

We hypothesized that the maximum mechanical power outputs that can be maintained during all-out sprint cycling efforts lasting from a few seconds to several minutes can be accurately estimated from a single exponential time constant (k(cycle)) and two measurements on individual cyclists: the peak 3-s power output (P(mech max)) and the maximum mechanical power output that can be supported aerobi...

To evaluate the time course of EMG frequency changes during a three-minute maximal effort cycling test (3MT) session and to examine which parameter between mean (MNF) and median (MDF) frequency is more suitable for evaluation of changes in neuromuscular function throughout a 3MT. Eighteen recreationally-active men volunteered to participate in this study. Maximum voluntary contraction (MVC) was...

This study investigated the changes in cardiorespiratory response and running performance of 9 male "Talent Identification" (TID) and 6 male Senior Elite (SE) Spanish National Squad triathletes during a specific cycle-run (C-R) test. The TID and SE triathletes (initial age 15.2 ± 0.7 vs. 23.8 ± 5.6 years, p = 0.03; V(O2)max 77.0 ± 5.6 vs. 77.8 ± 3.6 ml · kg(-1) · min(-1), nonsignificant) underw...