In this study, a novel multiscale combined creep strain and creep rupture model is proposed. By comparing to experimental data it was shown that the model provides accurate creep rupture predictions for unidirectional off-axis specimens. The creep strain model provides accurate predictions within the confines of the linear elastic restrictions used in its development. This creep strain and cree...

OBJECTIVES To evaluate the viscoelastic properties of demineralized dentin matrix. Stress-relaxation studies were done on matrices in tension and strain elongation or creep studies were done in both tension and compression. METHODS Mid-coronal dentin disks were prepared from extracted unerupted human third molars. Disks were 0.5 mm thick for stress-relaxation or tensile creep experiments and ...

The scale dependence of the strength of virtually homogeneous rock is usually considered to be insignificant but the spectrum of discontinuities plays a very important role for the strength of differently sized rock elements and also controls the rock creep strain. Large-scale load tests comprised recording of the creep strain rate that was found to be strongly retarded and negligible for stres...

This study tested the hypothesis that late weaning and the availability of creep feed during the suckling period compared with early weaning, improves feed intake, decreases stress and improves the integrity of the intestinal tract. In this study with 160 piglets of 16 litters, late weaning at 7 weeks of age was compared with early weaning at 4 weeks, with or without creep feeding during the su...

This paper is concerned with a fatigue study of composite adhesive lap joints produced from a bi-directional woven E-glass fibres and polypropylene. The adhesive used was a Bostik 7452 (Rubber & Plastics Grade) ethyl cyanoacrylate type. The effects of layer orientation, lap joint length and water immersion on the fatigue behaviour were studied. The specimens were immersed in water during period...

The autonomous repair mechanism of creep cavitation during high-temperature deformation has been investigated in Fe-Au and Fe-Au-B-N alloys. Combined electron-microscopy techniques and atom probe tomography reveal how the improved creep properties result from Au precipitation within the creep cavities, preferentially formed on grain boundaries oriented perpendicular to the applied stress. The s...

The present paper will describe an approach for the simultaneous real-time compensation of hysteresis, creep and force-dependence effects of a piezoelectric stack actuator by a feed-forward controller. The basis of the feed-forward controller is given by so-called complex creep and hysteresis operators, which when adequately implemented, lead to a precise model of the creep and hysteresis chara...

PURPOSE Absorbable suture anchors offer great advantages but are made of mechanically weak material. The weakest link in the fixation of soft tissue to bone may therefore be the anchor itself. In this study, several commercially available anchors were mechanically tested in vitro. TYPE OF STUDY Biomechanical bench study. METHODS Twelve absorbable suture anchor models were implanted into an ...

The creep behavior of a binary Mg-15 wt.% Gd alloy was investigated over the temperature range from 523 K to 743 K, i.e., in both single-phase region (the hexagonal close-packed solid solution Mg) and two-phase plus Mg5Gd precipitates). prepared by squeeze casting technique. In higher range, at 723 specimens were treated situ annealing prior testing. At 673 below, tested cast state. interpreted...

Interstitial fluid pressurization has long been hypothesized to play a fundamental role in the load support mechanism and frictional response of articular cartilage. However, to date, few experimental studies have been performed to verify this hypothesis from direct measurements. The first objective of this study was to investigate experimentally the hypothesis that cartilage interstitial fluid...