Batch adsorption of recalcitrant melanoidin using the abundantly available coal fly ash was carried out. It had low specific surface area (SBET) of 1.7287 m2/g and pore volume of 0.002245 cm3/g while qualitative evaluation of the predominant phases in it was done by XRD analysis. Colour removal efficiency was found to be dependent on various factors studied. Maximum colour removal was achieved ...

In the present work, the ash transformation and deposition behavior during wheat straw and wood waste combustion were investigated by combustion experiments in an entrained flow reactor. The influence of sewage sludge addition on ash chemistry and deposition tendency was also studied. During combustion wheat straw, fine fly ash particles smaller than 2.5 μm are mainly formed due to vaporization...

Prediction of carbon content in fly ash is a valuable index in both designing and optimizing coal-fired boilers. In this study, methods of multiple regression (MR), decision trees (DT), and support vector regression (SVR) were used for prediction of unburned carbon content of fly ash in a 300-MW power plant with a tangentially fired furnace using a low-NOx concentric firing system. Twenty-one b...

The objective of this study was to determine the chemical, radiological and leaching properties of slag and ash produced by a thermoelectric unit of a former factory Adriavinil and deposited in the area of Kasktel Gomilica near Split, Croatia. A total of 33 samples were analysed. The bioavailable fraction of the slag and ash was estimated using different leaching tests. The waste material was c...

Olive oil is concentrated in the Mediterranean basin countries. Since the olive oil industries are incriminated for a high quantity of pollution, it has become imperative to solve this problem by developing optimized systems for the treatment of olive oil wastes. This study proposes a solution to the problem. Burned olive waste ash is evaluated for using it as clay stabilizer. In a laboratory, ...

Radiation doses from airborne effluents of model coal-fired and nuclear power plants (1000 megawatts electric) are compared. Assuming a 1 percent ash release to the atmosphere (Environmental Protection Agency regulation) and 1 part per million of uranium and 2 parts per million of thorium in the coal (approximately the U.S. average), population doses from the coal plant are typically higher tha...

and ECA coal analysers have been used to control sorting and blending operations at coal mines, power plants and coal terminals. In sorting operations, the analyser results are used to sort coal into piles, bins or silos based on the measured quality. Coals can be sorted by the ash, sulphur, moisture, heating value, or by combinations of these. Sorting can be used to allow low-ash coals to bypa...

Lignite from Mae Moh mine is the largest source of solid fuel for electricity generation in Thailand. It is used in pulverized coal-fired boilers of a 2400 MW thermal power plant. Its high CaO content in ash is a major concern that can affect severe slagging. In this paper, potential of slag occurrence in the power plant was investigated by numerical simulation. The FactSage thermochemical pack...

This study investigates the flotation performance of a representative hard coal slime sample (d80 particle size of minus 0.2 mm) obtained from the Prosper-Haniel coal preparation plant located in Bottrop, Germany. Flotation was carried out with a newly designed flotation cell refurbished from an old ultrasonic cleaning bath (2.5 L volume) equipped with a single frequency (35 kHz) and two differ...