PV array is increasingly employed for water pumping system. In this paper, the developed boost converter steps up the voltage produced by the PV array to a value which is suitable to run a single-phase induction motor. The inverter converts DC to AC is controlled by using sinusoidal pulse width modulation (SPWM) technique. By using a LCfilter the harmonics are eliminated and pure sine wave is o...

The effects of the diffuser vane on the performances of the multistage centrifugal pump were investigated experimentally, taking account of the interactions among the diffuser vane, the return vane, and the next stage impeller. It is very important to match well the diffuser vane with the return vane, for improving the hydraulic efficiency of the pump. The efficiency may be more improved by mak...

To study the influence of arterial pulse pressure on renin release, a chronic pulseless calf preparation was developed using a centrifugal left ventricular bypass blood pump. After pump implantation and recovery, control measurements of renal vein and arterial plasma renin activity, arterial pressure, and renal artery flow were obtained. The centrifugal bypass pump rate then was increased to ca...

In this paper, two centrifugal model tests (case 1: raft foundation, case 2: 2x2 piled raft foundation) were conducted in order to evaluate the effect of ground subsidence on load sharing among piles and raft and settlement of raft and piled raft foundations. For each case, two conditions consisting of undrained (without groundwater pumping) and drained (with groundwater pumping) conditions wer...

This paper presents the optimal operation of a photovoltaic pumping system. The operation of a permanent magnet brushless DC motor driving a centrifugal pump is investigated. The motor is controlled through a hysteresis current loop and an outer speed loop with a PI type controller. The proportional and integral gains are set to their optimal values. In order to optimise the overall system effi...

The article presents the results of research devoted to design and numerical calculation a low-flow high-head centrifugal pump with Barske-type impeller using computer simulation methods. main features fluid flow hydrodynamics, as well influence number geometry on energy cavitation characteristics pump, are found. focus is analysis end gap between blades casing, qualities pump. issue different ...

The Hydraulic Institute has just completed the task of developing a new ANSI/HI standard on Rotodynamic (Centrifugal) Slurry Pumps covering nomenclature, definitions, applications, and operation. The standard provides examples of all the different types of pumps available and has an extensive section on definitions. Slurries and their effect on performance and wear are covered. A slurry service...