Cracking is a major concern in welding aluminum alloys. Although weld solidification cracks can be eliminated through addition of filler alloy, the additives modify the alloy or base-metal constituents and may not always be desirable. High-energy beam processes, such as electron-beam welding, that result in minimal heat input reduce crack sensitivity, but their high cost limits their applicatio...

During casting of aluminum alloys, the partially solidified material is submitted to thermally induced strains that can lead to severe casting defects, such as hot tearing. In this work, carried out in the frame of the European project VIR[CAST], the rheological behavior of a partially solidified AA5182 aluminum alloy has been investigated in order to provide constitutive equations to predict h...

We report quantitative measurements of the impact of alloy disorder on the ν = 5/2 fractional quantum Hall state. Alloy disorder is controlled by the aluminum content x in the Al(x)Ga(1-x)As channel of a quantum well. We find that the ν = 5/2 state is suppressed with alloy scattering. To our surprise, in samples with alloy disorder the ν = 5/2 state appears at significantly reduced mobilities w...

Abstract: The supersolidus liquid phase sintering characteristics of commercial 2024 pre-alloyed powder was studied at different sintering conditions. Pre-alloyed 2024 aluminum alloy powder was produced via air atomizing process with particle size of less than 100 µm. The solidus and liquidus temperatures of the produced alloy were determined using differential thermal analysis (DTA). The sinte...

An Aluminum based in-situ alloy reinforced with Mg2Si and Si hard particles produced by casting Al-6Si-0.5Mg alloy. The microstructure, tensile properties and fracture behavior of the alloy were investigated and the results show that the Mg2Si and Si hard particles produced by precipitation hardening have great effects. The homogenized (24hr at 500 o C) and solutionized (2hr at 540 o C) cast al...

automotive and aerospace industries are required to light materials which have high properties. this causes to reduce production cost and fuel consumption. one of these advanced materials that have been attracted at these decades is particulate metal matrix nanocomposites. these materials have a combination of ductile matrix alloy properties and ceramic reinforcement nanoparticles. powder metal...

The fabrication of a composite membrane of nanoporous gold nanowires and anodic aluminum oxide (AAO) is demonstrated by the electrodeposition of Au-Ag alloy nanowires into an AAO membrane, followed by selective etching of silver from the alloy nanowires. This composite membrane is advantageous for flow-through type catalytic reactions. The morphology evolution of the nanoporous gold nanowires a...

In this study the Taguchi method, has been applied to optimize the heat treatment parameters for the corrosion resistance of AA6061 aluminum alloy. The experimental design consisted of four parameters (aging temperature, aging time, quenching environment and NaCl concentration), each containing three levels. Tafel polarization measurements were carried out to determine the corrosion resistance ...

The evolution of surface topography and crystallographic texture was investigated under balanced biaxial stretching in sheets of the aluminum alloy 5052-H32. Two different lots of material, with an initial nominal thickness of 1 mm, were tested in the as-received condition. Samples with increasing levels of balanced biaxial strain were deformed using a modified Marciniak in-plane stretching tes...

Rice Husk Ash (RHA) of three different particle size ranges (50 – 75 μm), (75 – 100μm) and (100 – 150μm) in 3, 6, 9 and 12 % by weight was reinforced with the aluminium alloy using stir cast route. The microstructure and mechanical properties of the fabricated composites were analyzed. The results reveal that the tensile strength, compressive strength and hardness of the aluminum alloy composit...