The fibrogenic potential of 11 different welding fumes and metallic aerosols, considered to be reference standard surrogates for the commonly used welding technologies and applications responsible for 70% of welders exposure, is screened by using the rat peritoneal macrophage (RPM) in vitro bioassay. Only one class of fumes, that from the manual metal are welding of stainless steel, shows disti...

D. Bajic, University of Montenegro, Faculty of Mechanical Engineering, G. Vladimirovich Kuzmenko, E.O. Paton Electric Welding Institute, National Academy of Sciences Ukraine, I. Samardžić, J.J.Strossmayer university of Osijek, Mechanical Engineering Faculty in Slavonski Brod, Croatia The paper presents up-to-date achievements in application of a new method of arc welding of various rail profi l...

The HASTELLOY® and HAYNES® alloys are known for their good weldability, which is defined as the ability of a material to be welded and to perform satisfactorily in the imposed service environment. The service performance of the welded component should be given the utmost importance when determining a suitable weld process or procedure. If proper welding techniques and procedures are followed, h...

The tube to tube sheet welding joints of heat exchanger is the most critical joints. A special Nondestructive testing technology was proposed, which is based on the digital radiographic imaging automatic inspection system to the characteristics on the tube to tube sheet welding joints of heat exchanger. A new style Linear Diode Arrays as a device is used to receive ray, which will be fixed on a...

Welding is an important process used in the iron based industries. About two percent of the working population is engaged in some type of welding. The procedure of welding is simple but its health implications are complex. Welding generates enormous amounts of gases and metal fumes. Depending on the substrate and welding type, the composition of resultant gases and fumes changes. Therefore, wel...

It is important to adjust the welding gun's inclination during automatic curved-joint tracking of arc welding. In this paper, a novel method is proposed to detect the deviation and inclination of the welding gun based on the arc currents acquired by a high-speed rotational arc sensor. It uses a least-squares method to fit the arc currents to a plane in three dimensions. The deviation and inclin...

Most of the inspection methods used for detection and localization of welding disturbances are based on the evaluation of some direct measurements of welding parameters. This direct measurement requires an insertion of sensors during the welding process which could somehow alter the behavior of the metallic transference. An inspection method that evaluates the GMA welding process evolution usin...

The application of laser ultrasonic technique is developed for evaluation of friction stir spot welding (FSSW) quality. The features of laser-generated ultrasonic waves in good welding and incomplete fusion area are simulated by finite element method (FEM). The non-contact laser ultrasonic inspection system (LUIS) was established to verify the numerical results. The interaction of laser ultraso...

Submerged arc welding also known as sub arc welding has become a chief welding process because of its ability to deposit large amounts of metal with high penetration. The quality of weld depends on bead geometry of the weld which in turn depends on the process variables. This paper deals with the application of factorial design approach for optimising four submerged arc welding parameters viz. ...

Welding time and joint preparation are among the most important factors dominating the cost and productivity of welding. If the desired penetration of the weld pool can be achieved in a single pass, the welding speed will be the major factor that determines the welding time. When the thickness of the part increases, grooves may have to be machined so that the desired penetration may still be ob...