In the current research work synthesis, characterization, mechanical and wear behavior of 5 and 10 wt. % of nano TiO2 particulates reinforced Al7075 alloy composites are inspected. The Al7075 alloy and nano TiO2 particle composites were provided by melt stir system. After the preparation, the prepared composites were analyzed by SEM, EDS, and XRD for inquiring the microstr...

BACKGROUND AND PURPOSE Wear rates of highly crosslinked polyethylene (XLPE) acetabular components have varied considerably between different published studies. This variation is in part due to the different techniques used to measure wear and to the errors inherent in measuring the relatively low amounts of wear in XLPE bearings. We undertook a scoping review of studies that have examined the i...

In this investigation the friction and wear performance of GUR 1020 medical grade ultra-high molecular weight polyethylene (UHMWPE) polymer under dry sliding, distilled water and egg albumen lubrication conditions were evaluated. The sliding experiments were carried out on a pin-on-disc tribometer. The contact configuration used was a polymer pin on a rotating AISI 304L stainless steel disc. We...

The objective of this research is to study the dry sliding wear behaviour of metal surfaces and influences of their surface hardness. The improved hardness of the TiN deposited surface was about 1763 Hv. The worn surface Scanning Electron Microscope (SEM) morphology exhibits the surface damage due to varying wear test parameters. The Electron Dispersive Spectroscopy (EDS) reveals that the mater...

Nano-scratch and nano-indentation were used to determine hardness, elastic modulus, adhesion, friction and wear resistance of chromium oxide coatings in air and in water. The friction coefficient is higher in water, compared to air, and it increases with the applied normal load, although there are no obvious differences in hardness and elastic modulus in air vs. water. A higher normal load incr...

This paper describes the tool life prediction model with end milling EN31 tool steel using P30 Tungsten uncoated carbide tool. The data set from the Taguchi method design is taken. For discussion the effects of cutting speed, feed rate and depth of cut on tool life of P30 are considered. This paper suggests a novel technique for the tool wear measurement based on machine vision. Tool images are...

PURPOSE To examine the rabbit corneal epithelial cell proliferation rate after extended wear of disposable or silicone hydrogel contact lenses or prolonged eyelid closure. METHODS One randomly chosen eye of 40 New Zealand White rabbits was assigned to silicone hydrogel contact lens wear (n = 15, SH), disposable hydrogel contact lens wear (n = 6, DH), eyelid suturing (n = 15, SUT), or no inter...

Oxidative degradation of ultra-high molecular weight polyethylene (UHMWPE; PE), due to gamma irradiation sterilization in air, increases wear rate in artificial joint. Not only adhesive and abrasive wear but also delamination (flaking), a typical wear of the PE component in artificial knee joint, and fracture could be observed. This paper deals with gamma-irradiation effects on severe wear mech...

Carbon-fiber-reinforced silicon carbide (C/C-SiC) composite is widely used as a friction material owing to its good performance, even though it is more expensive than metallic materials. The light C/C-SiC composite is an ideal candidate for weight reduction of frictional parts. In this study, the friction and wear behavior of C/C-SiC composite was assessed using a ball-on-disk friction tester u...

INTRODUCION: Improved wear resistance of crosslinked UHMWPE has been well demonstrated in both hip and knee [1-4]. A reduction of 70% can be shown in knee simulators from conventional crosslinked tibial inserts (CXPE) gamma-irradiated at 3.5Mrad to 7Mrad highly crosslinked inserts (HXPE). Hip simulator models indicated that debris size decreased with increased crosslinking [5]. In the knee it h...