In nuclear power plants, the main corrosion product that is deposited on the outside of steam generator tubes is porous magnetite. The objective of this study was to simulate porous magnetite that is deposited on thermally treated (TT) Alloy 690 steam generator tubes. A magnetite layer was electrodeposited on an Alloy 690TT substrate in an Fe(III)-triethanolamine solution. After electrodepositi...

Effects of pretreatments with trehalose on drying of sliced vegetables (potato and carrot) were experimentally investigated. Two different pretreatment methods were tested. Sliced vegetables were steam-blanched and then immersed in a sugar solution. In another method sliced vegetables were coated with sugar powder, and then steam-blanched. Solid gain and water loss during pretreatment were meas...

De-Ionized (DI) water is ubiquitous within the Fab. Purity and consistency of DI is critical to manufacturing process. Urea is a known contaminant that is difficult to control and has large seasonal fluctuations. Normally stable at room temperature, Urea has a high conversion rate to Ammonia when boiled. DI water is often converted to steam and then injected into cleanroom air to control humidi...

A short echo time (TE = 24 ms) semiadiabatic localization by adiabatic selective refocusing (LASER) sequence was designed and optimized for full-intensity proton magnetic resonance spectroscopy ((1) H MRS) at 4 T. The sequence was combined with VAPOR water suppression and three-dimensional outer volume suppression for improved localization and suppression of unwanted coherences. Artifact-free, ...

Green bamboo was hydrolyzed over a range of durations at different temperatures. A simple pseudo-homogeneous irreversible first order kinetic model was developed to describe pentosan solubility during steam treatment of green bamboo. To avoid the influence of soluble pentosan during heating process, kinetic parameters were effectively dissolved based on the data in the reacting process. Moreove...

Tests are reported on a small (110 mm diameter main rotor) singlescrew air compressor adapted for use with steam. A novel gaterotor design was employed with sliding pads to take up tooth flank clearances. There was also water atomisation into the suction. The test rig allowed preliminary runs to be made on nitrogen at 2990 and 5600 RPM. The best volumetric efficiency was only 57% and this was d...

A technique capable of capturing the dynamics of reservoir fluids in the proximity of production wells would provide enormous benefits to the reservoir management. In fact, monitoring can be used to develop a feedback loop between measurements and control technologies to optimize production. This paper validates the feasibility of a borehole radar tool as a permanent down-hole sensor for near-w...

This paper reanalysed the 255 sets of geothermal two-phase flow data of Freeston et al (1983). A new void fraction correlation is proposed in this paper. The new correlation is derived from the analysis of two-phase flow velocity distribution using the Seventh Power Law as: To predict the two-phase pressure drop, an equivalent pseudosingle-phase flow having the same boundary layer velocity dist...

The relative permittivity (or static dielectric constant) of water and steam has been experimentally calculated at a relatively wide range of temperatures and pressures. A single function for predicting the relative permittivity of water and steam in three distinct thermodynamic regions is evolved using genetic programming. A data set comprised of all of the most accurate relative permittivity ...