purpose: to investigate the results of deep lamellar keratoplasty (dlk) by big bubble method with using shifting bubble sign in patients suffering from keratoconus or corneal opacity methods: in this prospective interventional clinical trial, 20 eyes of 18 patients (10 males and 8 females) who underwent dlk by big bubble method using shifting bubble sign were investigated. mean age of cases wer...

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 Slurry ice, a biphasic system consisting of small spherical ice crystals surrounded by seawater at subzero temperature, was evaluated as a new chilled storage method for European hake (Merluccius merluccius), a gadoid fish species of remarkable commercial interest, an compared with a control batch stored f...

Chemical mechanical polishing (CMP) is a manufacturing process in which a wafer surface is polished by pressing it against a rotating pad that is flooded with slurry. The slurry itself is a fluid containing abrasive particles. Past experimentation has shown that the distribution of suspended particles in the slurry is significantly related to the distribution of material removal on the wafer du...

A laboratory scale aeration treatment system was built to study the fate of nitrogen during aeration of pig slurry. For each run evaluated, the nitrogen mass balance was determined including measurement of the nitrous oxide gas emissions. Intermittent aeration led to a nitrogen removal of about 53% of the total nitrogen content of the raw slurry. About 18% of the total nitrogen content of the r...

In the present study, the ice slurry refrigeration system with pre-cooling heat exchanger (ISSH) is studied experimentally to achieve the system performance, ice crystal formation time and the temperature of ice crystal formation. The operating parameters considered in this paper include the concentration of salt solution, suction pressure, discharge pressure and Energy Efficiency Ratio (EER). ...

To analyze the flow of an underfill encapsulant between the chip and substrate, a shear viscosity model is needed. This paper presents a model of the viscosity for the flow of slurry between two parallel walls, which is a typical situation found in electronic packaging applications. It is postulated that the flow behavior of a dense slurry is governed by the particle-particle and particle-wall ...

The direct synthesis process of dimethyl ether (DME) from syngas in slurry reactors is considered to be promising because of its advantages in caloric transfer. In this paper, the influences of operating conditions (temperature, pressure and weight hourly space velocity) on the conversion of CO, selectivity of DME and methanol were studied in a stirred autoclave over Cu-Zn-Al-Zr slurry catalyst...

BACKGROUND Environmental issues, such as the fossil energy crisis, have resulted in increased public attention to use bioethanol as an alternative renewable energy. For ethanol production, water and nutrient consumption has become increasingly important factors being considered by the bioethanol industry as reducing the consumption of these resources would decrease the overall cost of ethanol p...

In present paper acombination of three-dimensional isothermal and two-dimensional non-isothermal Lattice Boltzmann Method have been used to simulate the motion of bubble and effect of wetting properties of the surface on bubble separation. By combining these models, three-dimensional model has been used in two-dimension for decreasing the computational cost. Firstly, it has been ensured that th...

In this study, the effect of slip casting parameters on the ultrafine microstructure and the density of pore-free YAG ceramic was evaluated. A stable, high concentrated aqueous YAG slurry using Dolapix-CE64 as a dispersant was prepared. The effect of dispersant concentration as well as the solid load on the stability and rheological behavior of the slurry was also studied. The optimal dispersan...