field observations of the incurred damages to the buildings and bridges due to earthquakes in near field show there are various failure modes which are in relation to the forces caused by vertical component. while vertical component of earthquake for ordinary buildings in most seismic regulations and standards is not considered. therefore, in the current study the effects of vertical and horizo...

this study is investigated the optimum parameters for a tuned mass damper (tmd) under the seismic excitation. shuffled complex evolution (sce) is a meta-heuristic optimization method which is used to find the optimum damping and tuning frequency ratio for a tmd. the efficiency of the tmd is evaluated by decreasing the structural displacement dynamic magnification factor (ddmf) and acceleration ...

The Sirri jacket offshore platform was designed and installed in Persian gulf of Iran in 1975 and has been in service since that time. The importance of offshore structure's stability and the failure of this kind of structure during an earthquake in different active zones revealed that earthquake loading has to be considered. In this paper, Magnetorheological (MR) fluid dampers have been propos...

Tsunami generation by an earthquake is generally modeled by water surface displacement identical to the vertical deformation of ocean bottom due to faulting. The effect of horizontal deformation is usually neglected. However, when the tsunami source is on a steep slope and the horizontal displacement is large relative to the vertical displacement, the effect becomes significant. We show this fo...

Structural damage can be controlled in performance based seismic design (PBSD) according to the requirement under a certain hazard level. During strong ground motion (GM) such buildings suffer minor to major damages depending on the shaking level of GM. The available damage assessment methods are complex, tedious and time-consuming procedure. In the present study, a simplified empirical model h...

Abstract—This paper presents a numerical investigation on the seismic performance of a benchmark bridge with different optimal isolation systems under near fault ground motion. Usually, very large displacements make seismic isolation an unfeasible solution due to boundary conditions, especially in case of existing bridges or high risk seismic regions. Hence, near-fault ground motions are most l...

This study investigates the efficacy of optimal semi-active dampers for achieving the best results in seismic response mitigation of adjacent buildings connected to each other by magnetorheological (MR) dampers under earthquakes. One of the challenges in the application of this study is to develop an effective optimal control strategy that can fully utilize the capabilities of the MR dampers. H...

This paper describes the results of an extensive study on the seismic behavior of a structure with damper and without damper under different earthquake acceleration frequency like Earthquake Altadena, Earthquake Lucerne and Earthquake New Hall. It is observed through nonlinear time history analysis that maximum displacement, maximum base shear and maximum acceleration can be effectively reduced...

This paper presents results obtained by numerical study of sloshing effects in medium sized rectangular tanks subjected to a long-period seismic excitation. The Smoothed Particle Hydrodynamics (SPH) method is used, and the wave displacement and pressure are analysed. The intensity of sloshing effects depends not only on the peak ground acceleration but also on the dominant frequency of ground m...

Elevated water tanks supported by the reinforced concrete (RC) Staging are classified as inverted pendulum structures. These are considered as structures of high post-earthquake importance and should remain functional after the seismic events. National codes of various countries recommend Force-Based Design (FBD) procedure for water tank staging, which does not ensure nonlinear performance leve...