Rate effects for adhesively-bonded joints in steel sheets failing by mode-I fracture and plastic deformation were examined. Three types of test geometries were used to provide a range of crack velocities between 0.1 mm/s and 5000 mm/s: a DCB geometry under displacement control, a wedge geometry under displacement control, and a wedge geometry loaded under impact conditions. Two fracture modes w...

16 This paper presents a novel large-area strain sensing technology for monitoring fatigue cracks in 17 steel bridges. The technology is based on a soft elastomeric capacitor (SEC), which serves as a 18 flexible and large-area strain gauge. Previous experiments have verified the SEC’s capability to 19 monitor low-cycle fatigue cracks experiencing large plastic deformation and large crack openin...

The effects of loading conditions, specimen size and metal particle size on the crack growth resistance curve (R-curve) and residual strength of a ceramic-metal functionally graded material (FGM) are studied based on the crack-bridging concept. It is found that the FGM exhibits strong R-curve behavior when a crack grows from the ceramic-rich region toward the metal-rich region and the residual ...

[1] Documenting the morphology and distribution of polygonally patterned ground on Mars is critical for understanding the age and origin of the Martian latitude-dependent mantle. Polygonally patterned ground on Mars is analyzed using High Resolution Imaging Science Experiment image data in order to document the variation of polygon morphology within latitude bands 30–80 in both northern and sou...

Fretting fatigue induced by combined localized cyclic contact motion and external bulk fatigue loadings may result in premature and dramatic failure of the contacting components. Depending on fretting and fatigue loading conditions, crack nucleation and possibly crack propagation can be activated. This paper proposes a procedure for estimating these two damage thresholds. The crack nucleation b...

http://dx.doi.org/10.1016/j.actamat.2015.07.022 1359-6454/ 2015 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved. ⇑ Corresponding author at: Department of Materials Science & Engineering, University of California, Berkeley, CA 94720, USA. E-mail address: [email protected] (R.O. Ritchie). 1 Intrinsic toughening mechanisms operate ahead of the crack tip to resistance to microst...

Centrifugal compressors are a key piece of equipment for modern production. Among the components of the centrifugal compressor, the impeller is a pivotal part as it is used to transform kinetic energy into pressure energy. Blade crack condition monitoring and classification has been broadly investigated in the industrial and academic area. In this research, a pressure pulsation (PP) sensor arra...

Cracking and fracture of electrodes under diffusion during lithiation and delithiation is one of the main factors responsible for short life span of lithium based batteries employing high capacity electrodes. Coupling effects among lithium diffusion, stress evolution and crack propagation have a significant effect on dynamic processes of electrodes during cycling. In this paper, a phase field m...

Fatigue crack growth rate depends not only on the load amplitude, but also on the morphology of crack path. The strain energy density theory has the ability to analyze crack growth rate. A strain energy density crack growth model is proposed. It can predict the lifetime of fatigue crack growth for mixed mode cracks while an equation for mode I crack is also obtained. The validity of the model i...

structural health monitoring of cracked structures is one of beloved subject of researchers recently. consider of crack behavior in the water and energy pipeline is important because of environmental problems. in this paper consider of crack parameters in the underwater pipe subjected to mechanical transient load is investigated. for this purpose, three- dimensional parametric model of cracked ...