In this investigation, a laser cladding process with a powder feeding was used to deposit stainless steel 410L (high strength, excellent resistance to abrasion and corrosion, and great laser compatibility) onto railhead (higher strength, heat treated hypereutectoid rail grade manufactured in accordance with the requirements of European standard EN 13674 Part 1 for R400HT grade), to investigate ...

Welding is a reliable and effective metal fabrication process which is widely used in industries. High heating at a one location during welding and further rapid cooling generates residual stress and distortion in the weld and base metal. In last few decades various research efforts have been directed towards the control of welding process parameter aiming at reducing residual stress and distor...

The predictions of residual stresses are most critical on the machined aerospace components for the safety of the aircraft. In this paper, an enhanced analytic elasto-plastic model is presented using the superposition of thermal and mechanical stresses on the workpiece, followed by a relaxation procedure. Theoretical residual stress predictions are verified experimentally with X-ray diffraction...

Thermal effects on the pin-bearing behavior of an IM7/PETI5 composite laminate are studied comprehensively. A hypothesis presents factors influencing a change in pin-bearing strength with a change in temperature for a given joint design. The factors include the change in the state of residual cure stress, the material properties, and the fastener fit with a change in temperature. Experiments ar...

The mechanical behavior of freestanding gold membranes 0.5 micron thick with and without passivation layers was studied with a membrane deflection experiment. Membrane width was varied from 2.5 to 20 microns to investigate size effects. The presence of the passivation layer had the effect of reducing the membrane strength. Yield stress, as well as fracture strain and stress, were all found to b...

............................................................................................................................ii APPENDED PAPERS.................................................................................................................iii DIVISION OF WORK BETWEEN AUTHORS.................................................................................iv TABLE OF CONTENTS........

The degree of polymerization of an acrylic resin repair material, as established by residual monomer estimation, was compared using three different polymerization methods, i.e. bench-cure, hydroflask-cure and microwave irradiation cure. The repair strength of a conventional heat-polymerized resin was then assessed following repairs using each of these three methods. The lowest level of residual...