Transient overvoltages appearing at line terminal of power transformer HV windings can cause failure of winding insulation. The failure can be from winding to ground or between turns or sections of winding. In most of the cases, failure from winding to ground can be detected by changes in the wave shape of surge voltage appearing at line terminal. However, detection of insulation failure betwee...

Fault diagnosis of full-scan designs has been progressed significantly. However, most existing techniques are aimed at a logic block with a single fault. Strategies on top of these block-level techniques are needed in order to successfully diagnose a large chip with multiple faults. In this paper, we present such a strategy. Our strategy is effective in identifying more than one fault accuratel...

Fault diagnosis of full-scan designs has been progressed significantly. However, most existing techniques are aimed at a logic block with a single fault. Strategies on top of these block-level techniques are needed in order to successfully diagnose a large chip with multiple faults. In this paper, we present such a strategy. Our strategy is effective in identifying more than one fault accuratel...

Seismic hazard analysis of vulnerable countries on the Alpine-Himalayan belt has great importance to be considered. Recently, Iran as one of the countries located on the stated belt has experienced a few number of severe earthquakes. A wellestablished index of how earthquakes affect buildings is by assessing probable Peak Ground Acceleration (PGA) which can be estimated by past events. For this...

Fling-step and forward directivity are two important characteristics of near-field earthquakes. Forward directivity occurs when the rupture propagates toward the site and arises in fault‐normal direction for strike‐slip faults. Fling-step is the consequence of permanent ground displacement imposed by near-field earthquakes and arises in strike-slip faults in the strike parallel direction. Fling...

Roberto Natella Università degli Studi di Napoli Federico II, Italy ABSTRACT This paper proposes an approach to software faults diagnosis in complex fault tolerant systems, encompassing the phases of error detection, fault location, and system recovery. Errors are detected in the first phase, exploiting the operating system support. Faults are identified during the location phase, adopting o...

The growing number of circuits implemented in Field Programmable Gate Arrays (FPGAs) and the increased susceptibility, due to higher integration levels, of these devices to soft faults caused by radiation at ground level is leading the scientific and technical community to the study of new fault tolerant designs and solutions, and how they can be verified and validated. Using fault injection te...

In this paper, a new very fast fault simulation method to handle the X-fault model is proposed. The method is based on a two-phase procedure. In the first phase, a parallel exact critical path fault tracing is used to determine all the detected stuck-at faults in the circuit, and in the second phase a postprocess is launched which will determine the detectability of X-faults. Keywords-digital c...

Successful software process improvement depends on the ability to analyze past projects and determine which parts of the process that could become more efficient. One typical data source is the faults that are reported during product development. From an industrial need, this paper provides a solution based on a measure called faults-slip-through, i.e. the measure tells which faults that should...

Fault detection and identification methods (FDI) are an important aspect for ensuring consistent behavior of technical systems. In robotics FDI promises to improve the autonomy and robustness. Existing FDI research in robotics mostly focused on faults in specific areas, like sensor faults. While there is FDI research also on the overarching software system, common data sets to benchmark such so...