It is well known that the viscosity of fluids could vary by several orders of magnitude with pressure. This fact is not usually taken into account in many important applications involving the flow of fluids through a porous media, like the problems of enhanced oil recovery or carbon dioxide sequestration where very high pressure differentials are involved. Another important technical problem wh...

An experimental investigation of oil retention and pressure drop characteristics for R1234yf, R134a and R410A with POE 100 is presented, for horizontal and vertical suction lines of 10.2 mm internal diameter. Conditions of operation include a saturation temperature of 13 °C and a superheat of 15 °C, with the superficial vapor velocity and the Oil in Circulation Ratio (OCR) both varied in the ra...

gas injection into heavy oil reservoirs could result in high ultimate recovery of oil. experimental studies showed that an application of a combined technology of gas assisted gravity drainage (gagd) and vapor extraction (vapex) could increase final oil recovery of a candidate viscous oil reservoir. in this paper the results of laboratory investigation are presented, including pressure-volume-t...

Abstract—Five palm oil ether monoesters utilized as novel biodiesels were synthesized and structurally identified in the paper. The investigation was made on the effect of ether species on physicochemical properties of the palm oil ether monoesters. The results showed that density, kinematic viscosity, smoke point, and solidifying point increase linearly with their –CH2 group number in certain ...

The bioemulsifier V2-7 is an exopolysaccharide (EPS) synthesized by strain F2-7 of Halomonas eurihalina and it has the property of emulsifying a wide range of hydrocarbons i.e. n-tetradecane, n-hexadecane, n-octane, xylene mineral light and heavy oils, petrol and crude oil. Characteristics of exopolysaccharide V2-7 produced in media supplemented with various hydrocarbons (n-tetradecane, n-hexad...

Hydrolysed polyacrylamide (HPAM) mother liquor is mainly used to extract oil. The HPAM solution is needed to filter the impurity using a bag filter before it is injected into the oil well. Therefore, the pressure drop of HPAM mother liquor must be less than 0.02 MPa in the processing of impurity filtration. The influence factors on pressure drop need to be researched. In this work, the computat...

The steady deformation and breakup of emulsion drops in a uniform electric field are considered experimentally. Due to the low volume fraction of inner drops, the emulsions can be effectively assumed as Newtonian fluids with spatial nonuniformity. The measurements of the electrical properties show that the oil-in-water (o/w) emulsion drop behaves like a conducting drop. On the other hand, the w...

Enhanced oil recovery (EOR) has been identified as a method of sequestering CO2 recovered from power plants. In CO2flood EOR, CO2 is injected into an oil reservoir to reduce oil viscosity, reduce interfacial tension, and cause oil swelling which improves oil recovery. Previous studies suggest that substantial amounts of CO2 from power plants could be sequestered in EOR projects, thus reducing t...

Estolides are vegetable-oil-based lubricants obtained from oleic acid or any source of hydroxy fatty acids. In this work, the estolides synthesis from oleic acid and methyl ricinoleate (biodiesel from castor oil), using immobilized commercial lipases (Novozym 435, Lipozyme RM-IM, and Lipozyme TL-IM) in a solvent-free medium was investigated. Acid value was used to monitor the reaction progress ...

In this study, the lipophilic Cu nanoparticles were synthesized by surface modification method to improve their dispersion stability in hydrophobic organic media. The oil-based nanofluids were prepared with the lipophilic Cu nanoparticles. The transport properties, viscosity, and thermal conductivity of the nanofluids have been measured. The viscosities and thermal conductivities of the nanoflu...