We report in situ, real-time detection of soot particles coated with NaCl using excimer laser fragmentation fluorescence spectroscopy (ELFFS). Carbon atom fluorescence at 248 nm and the Na D-line at 589 nm are used as signatures of soot and NaCl, respectively. Soot particles are encapsulated with a NaCl layer in a well-controlled inverted flame burner. NaCl particles are injected into the metha...

Ignition, flame propagation and stabilisation have been simulated and analysed in a turbulent jet of non-premixed methane and air. The first order Conditional Moment Closure (CMC) turbulent combustion model was fully coupled with a Reynolds-Averaged Navier Stokes (RANS) flow simulation. A CMC model was developed to account for spark ignition. The over-prediction of turbulent flame propagation w...

Federal Aviation Administration te technical note technica te technical note technica NOTICE This document is disseminated under the sponsorship of the U.S. Department of Transportation in the interest of information exchange. The United States Government assumes no liability for the contents or use thereof. The United States Government does not endorse products or manufacturers. Trade or manuf...

A Photon Monte Carlo method combined with a composition PDF method is employed to model radiative heat transfer in combustion applications. Turbulence–radiation interactions (TRIs) can be fully taken into account using the proposed method. Sandia’s Flame D and artificial flames derived from it are simulated and good agreement with experimental data is found. The effects of different TRI compone...

Acoustically modulated methane jet diffusion flames were used to enhance carbon nanostructure synthesis. A catalytic nickel substrate was employed to collect the deposit materials at sampling position z = 10 mm above the burner exit. The fabrication of carbon nano-onions (CNOs) and carbon nanotubes (CNTs) was significantly enhanced by acoustic excitation at frequencies near the natural flickeri...

Simulations of forced ignition of non-premixed laminar counterflow flames are used to study the effect of strain rate on ignition success. A one dimensional calculation is performed, using detailed methane chemical kinetics and treating the spark as an instantaneous heat release in an inert mixing layer. Ignition success depends on the mixture composition at the spark location, resulting in lea...

The scalar mixing time scale, a key quantity in many turbulent combustion models, is investigated for reactive scalars in premixed combustion. Direct numerical simulations (DNS) of three-dimensional, turbulent Bunsen flames with reduced methane-air chemistry have been analyzed in the thin reaction zones regime. Previous conclusions from single step chemistry DNS studies are confirmed regarding ...

Laminar burning velocities and flammability limits of premixed methane/air flames in the presence of various inert gases including helium, argon, nitrogen and carbon dioxide were investigated by combined use of microgravity experiments and computations. The experiments used a short-drop free-fall laboratory facility that can eliminate the effect of buoyancy on flames and therefore enable accura...

1. Introduction Premixed turbulent flames are of increasing practical importance and remain a significant research challenge in the combustion community. These flames have the potential to operate cleanly and efficiently over a broad range of fuels, and therefore to represent a key element in the implementation of low-emissions burners for a variety of industrial applications. However, it is di...

The charge density in a flame contains important information about the combustion processes that is difficult to obtain due fast, complex, and highly exothermic reactions. This paper presents study of using electrostatic probes measure methane fired diffusion premixed flames. sensing principle, practical design, performance assessment probe are presented. Comparative experimental studies with r...