When a piezoelectric film is glued on the surface of a structure member subjected to mechanical load, a distribution of electric potential is induced. In the existence of defects in the member, a characteristic variation of electric potential is observed. Based on this phenomenon, the passive electric potential CT (computed tomography) method is developed for detecting and identifying defects i...

This paper describes the modeling of magnetoelectric (ME) effects for disk-type Terfenol-D (Tb0.3Dy0.7Fe1.92)/PZT (Pb(Zr,Ti)O₃) laminate composite at low frequency by combining the advantages of the static elastic model and the equivalent circuit model, aiming at providing a guidance for the design and fabrication of the sensors based on magnetoelectric laminate composite. Considering that the ...

The present study reports the influence of fiber orientation, laminate sequence and fabric type on the inherent nonlinearity of intact carbon fiber/epoxy composites using nonlinear resonant ultrasonic spectroscopy (NRUS) [1-2]. Fiber orientation of the CFRP samples were changed relative to the length of the sample. Since the fundamental flexural mode is excited, the properties of the composite ...

The work aimed to assess the failure progress in a glass fiber-reinforced polymer laminate with a 3D-woven and (as a comparison) plain-woven reinforcement, during static bending, using acoustic emission signals. The innovative method of the separation of the signal coming from the fiber fracture and the one coming from the matrix fracture with the use of the acoustic event's energy as a criteri...

We have investigated thermal conductivity of graphene laminate films deposited on polyethylene terephthalate substrates. Two types of graphene laminate were studied, as deposited and compressed, in order to determine the physical parameters affecting the heat conduction the most. The measurements were performed using the optothermal Raman technique and a set of suspended samples with the graphe...

(Abstract) Genetic algorithms are well known for being expensive optimization tools, especially if the cost for the analysis of each individual design is high. In the past few years, significant effort has been put forth in addressing the high computational cost GAs. The research conducted in the first part of this thesis continues this effort by implementing new multiple elitist and variable e...

A non-autoclave vacuum bag process using atmospheric pressure alone that eliminates the need for external pressure normally supplied by an autoclave or a press is an attractive method for composite fabrication. This type of process does not require large capital expenditures for tooling and processing equipment. In the molding cycle (temperature/pressure profile) for a given composite system, t...

in this paper, a closed form solution for bending and free vibration analyses of simply supported rectangular laminated composite plates is presented. the static and free vibration behavior of symmetric and antisymmetric laminates is investigated using a refined first-order shear deformation theory. the winkler–pasternak two-parameter model is employed to express the interaction between the lam...

1. Abstract Conventional wind turbine blades have been designed using fatigue life predictions based on a fixed wind load distribution that does not fully capture uncertainty of the wind load. This could result in early fatigue failure of blades and eventually increase the maintenance cost of wind turbines. To produce reliable as well as economical wind turbine blades, this paper studies reliab...

Laminate structures incorporating thin layers of metal and polymer, or polymer composite, can offer significant weight savings for engineering structures, while retaining excellent mechanical and impact performance. Laminates based on thin layers of aluminum and glassfiber/polypropylene thermoplastic have been the subject of recent study [1, 2], and have exhibited excellent specific mechanical ...