The purpose of this paper was to investigate the effects of Nb on the microstructure and elevated-temperature mechanical properties of Alloy 690-SUS 304L dissimilar welds. The results show that the welds were dominant with dendrites and interdendritic phases. In the low Nb welds, the main interdendritic phases were Nb-rich and Al-Ti-rich phases. Cr-carbides were precipitated along the grain bou...

Recommended Citation Sampath, Anand. "Comprehensive evaluation of four warm asphalt mixture regarding viscosity, tensile strength, moisture sensitivity, dynamic modulus and flow number. ii I dedicate this thesis to my parents, without whom I would not be where I am today iii ACKNOWLEDGMENTS

The effect of long period stacking ordered (LPSO) phase and γ' precipitates on the ageing behavior and mechanical properties of the extruded Mg-8.2Gd-3.8Y-1.0Zn-0.4Zr (wt.%) alloy was investigated. The results show that more β' phases precipitate during ageing treatment in the LPSO phase containing alloy so that the LPSO phase containing alloy exhibits a higher age-hardening response than the γ...

In this publication is presented optimization strength properties – tensile strength and elongation, of sintered structural materials of Fe-C-Cu system. Optimization is camed out by the method of simplex lattices adduced.Are presented grafphical relationships amending studied harakteristiks depending on the concentration of the elements in the triple system.

Dynamic mechanical analysis was used to record the behaviour of hydrated and dehydrated byssal threads under tensile stress and during dynamic thermal cycling. Fresh byssi, and byssi aged two weeks prior to testing, were used to further study the effects of age on the mechanical properties of this material. It was found that while older threads demonstrated increased stiffness, age did not nece...

Underground coal mining activities are prone to cause movement and breakage in geological strata and also lead to mining subsidence and even ground fissures. Along the direction working panel advancing, ground fissures may occur in roof in front and/or behind working panel. However, the investigations of previous similarity tests in lab only emphasize on the region behind working panel. By impr...

We propose a general framework for determining optimal relationships for tensile strength of doubly convex tablets under diametrical compression. This approach is based on the observation that tensile strength is directly proportional to the breaking force and inversely proportional to a non-linear function of geometric parameters and materials properties. This generalization reduces to the ana...

Melanin, a kind of well-known multifunctional biomacromolecules that are widely distributed in natural sources. In this work, polyurethane (PU)/melanin nanocomposites with enhanced tensile strength and toughness were successfully fabricated via in situ polymerization. It was found that the tensile strength (σ), elongation-at-break (εmax), and toughness (W) were improved from 5.6 MPa, 770%, and ...

The influence of martensitic microstructure and prior austenite grain (PAG) size on the mechanical properties of novel maraging steel was studied. This was achieved by looking at two different martensitic structures with PAG sizes of approximately 40 µm and 80 µm, produced by hot rolling to different reductions. Two ageing heat-treatments were considered: both heat-treatments consisted of auste...

[1] This paper revisits the Arctic Ice Dynamics Joint Experiment (AIDJEX) assumptions about pack ice behavior with an eye to modeling sea ice dynamics. The AIDJEX assumptions were that (1) enough leads were present in a 100 km by 100 km region to make the ice isotropic on that scale; (2) the ice had no tensile strength; and (3) the ice behavior could be approximated by an isotropic yield surfac...