This paper analyzes the optimal configuration and operating parameters of a heat exchanger in a geothermal district heating system. An optimization algorithm is presented for the nonlinear constrained problem to maximize the annual net profit for a system of counter-flow heat exchangers. Several parameters that affect the net profit are examined, including the mass flow rates of working fluids ...

0017-9310/$ see front matter 2010 Elsevier Ltd. A doi:10.1016/j.ijheatmasstransfer.2010.09.029 ⇑ Corresponding author. Tel.: +1 765 494 5705; fax E-mail address: [email protected] (I. Mud This study explores the use of a high-pressure metal hydride (HPMH), Ti1.1CrMn, to store hydrogen at high pressures (up to 310 bar) and temperatures below 60 C, conditions that are suitable for automobile...

for energy saving retrofit projects, its economics are usually evaluated in terms of capital investment and payback time. the capital investment is in direct relation to the total heat recovery area of the network and the payback time factor is base on both the area and the energy savings. the debottlenecking is an increased throughput, which can be profitable in economic sense. the combination...

debottlenecking of heat exchanger networks is a very important issue, when a plant is subject to process changes and/or increased throughput. in previous paper, a new targetting method was introduced, that allowed the designer to consider hydrodynamic constraints when debottlenecking a network. in this paper, a design procedure, which guarantees the consistency of the results of targetting stag...

The performance of the adsorption cooling system is assessed in terms of the heat transfer coefficients of adsorbent bed heat exchanger. These parameters in-turn determine the specific cooling capacity (SCC) and the coefficient of the performance (COP) of the adsorption cooling system. It was observed that the overall heat transfer coefficients of the heat exchanger have a direct linear relatio...

In this paper, a rigorous MILP formulation for grass-root design of heat exchanger networks is developed. The methodology does not rely on traditional supertargeting followed by network design steps typical of the Pinch Design Method, nor is a non-linear model based on superstructures, but rather gives cost-optimal solutions in one step. Unlike most models, it considers splitting, non-isotherma...

This study explores the endothermic dehydriding (desorption) reaction that takes place in a high-pressure metal hydride (HPMH) hydrogen storage system when hydrogen gas is released to the fuel cell. The reaction is sustained by circulating warm fluid through a heat exchanger embedded in the HPMH powder. A systematic approach to modeling the dehydriding process is presented, which is validated a...

The energy recovery performance of crude pre-heat trains (PHTs) in oil refineries is typically impaired by deposition over time of fouling on the thermal surfaces. Such time varying effects are normally not considered in the design or retrofit of heat exchangers networks. In this paper, the importance of taking into account such effects is demonstrated, bymeans of a case study. An existing indu...

Cross flow water tube heat exchanger can be designed and made operational using methods of model building and simulation of the system. This paper projects the design and development of a model of cross flow water tube heat-exchanger system, simulation and validation of control analysis of different tuning methods. Feedback and override control system is developed using inputs acquired with the...

An experimental study on the effects of various factors(fin spacing, fin arrangement, air temperature, air humidity, and air velocity) on the frost growth and thermal performance of a finned-tube heat exchanger has been conducted under the frosting condition. It is found that the thermal performance of a heat exchanger is closely related to the blockage ratio of air flow passage due to the fros...