This paper develops a novel data-driven fuzzy modeling strategy and predictive controller for boiler-turbine unit using fuzzy clustering and subspace identification (SID) methods. To deal with the nonlinear behavior of boiler-turbine unit, fuzzy clustering is used to provide an appropriate division of the operation region and develop the structure of the fuzzy model. Then by combining the input...

A simple two-by-two model for a boiler-turbine unit is demonstrated in this paper. The model can capture the essential dynamics of a unit. The design of a coordinated controller is discussed based on this model. A PID control structure is derived, and a tuning procedure is proposed. The examples show that the method is easy to apply and can achieve acceptable performance.

OBJECTIVES To evaluate the prevalence of perception and annoyance due to wind turbine noise among people living near the turbines, and to study relations between noise and perception/annoyance, with focus on differences between living environments. METHODS A cross-sectional study was carried out in seven areas in Sweden across dissimilar terrain and different degrees of urbanisation. A postal...

Conventional gas turbine generator sets consist of a high speed turbine coupled to a low speed alternator through a speed reduction gearbox. This is required to maintain the alternator output frequency at 50 Hz or 60Hz, as output frequency is directly proportional to speed. Since power is also directly proportional to speed, the conventional system is bulky and possesses a very large footprint....

Most of the electric power produced worldwide is based on fossil fuel combustion, largely in plants operating with low efficiency cycles. The large amounts of fuel consumed in this process release harmful emissions including toxic nitrogen and sulfur oxides, mercury, and greenhouse gases such as carbon dioxide. The necessity to reduce the negative impact of power generation on the environment, ...

Numerical simulations of complex large-scale flow systems must capture a variety of physical phenomena in order to predict the flow accurately. Currently, many flow solvers are specialized to simulate one part of a flow system effectively, but are either inadequate or too expensive to be applied to a generic problem. As an example, the flow through a gas turbine can be considered. In the compre...

Flow in the first two-stage of V 94.2 gas turbine is simulated numerically. In this turbine, the second stator is clocked relative to the first stator to different positions. Steady-state analysis was carried out by varying the circumferential relative position of the consecutive stator vanes to study the effects of the clocking on turbine performance. A density based compressible inviscid ...

The effect of two heat additions, rather than one, in a gas turbine engine is analyzed from the second law of thermodynamics point of view. A regenerative Brayton cycle model is used for this study, and compared with other models of Brayton cycle. All fluid friction losses in the compressor and turbine are quantified by an isentropic efficiency term. The effect of pressure ratio, turbine inlet ...

The anti-suck-back ability of five new high-speed air turbine handpiece models was evaluated in this study. First, suck-back pressure with water displacement within a glass tube was measured. Next, under three different conditions, how many on-off times it takes before fluorescent stains became visible on a piece of gauze at the exhaust vent was counted and the presence of fluorescent stains on...

Inadequate design and improper mixing operation in anaerobic digesters often lead to poor mixing and digester failures due to the presence of dead zones formed in the digester. More research is required to understand the mixing phenomena in anaerobic digesters and thus improve their efficiency. This paper investigates the efficiency of mixing of digester sludge in a mechanically agitated vessel...