STATEMENT OF PROBLEM Despite the favorable properties of conventional PMMA used as a denture base material, its fracture resistance could be improved. PURPOSE This in vitro study was performed to determine whether the flexural strength of a commercially available, heat-polymerized acrylic denture base material could be improved through reinforcement with 3 types of fibers. MATERIAL AND METH...

The aim of this study was to verify the influence of an experimental heat treatment (170 masculineC/10 min) using a casting furnace on the mechanical properties (hardness and flexural strength) of 2 commercial direct resin composites (TPH Spectrum and Filtek P60) compared to a commercial indirect resin system (BelleGlass). Heat treatment temperature was determined after thermal characterization...

The size dependence of flexural properties of cement mortar and concrete beams is investigated. Bazant's size effect law and modified size effect law by Kim and Eo give a very good fit to the flexural strength of both cement mortar and concrete. As observed in the test results, a strong size effect in flexural strength is found in cement mortar than in concrete. A modification has been suggeste...

This project presents the results of an experimental investigation of graphene oxide on physical properties of concrete. This article aims to find out the optimum quantity of graphene oxide required to achieve maximum compressive, tensile and flexural strength of concrete. Graphene oxide was added to the concrete in three mix proportions. Graphene oxide content were varied by 0.05%, 0.1%, 0.2% ...

The paper presents new results on the localization and transmission of flexural waves in a structured plate containing a semi-infinite two-dimensional array of rigid pins. In particular, localized waves are identified and studied at the interface boundary between the homogeneous part of the flexural plate and the part occupied by rigid pins. A formal connection has been made with the dispersion...

The purpose of this study was to investigate the deformation and flexural properties of acrylic and urethane polymers reinforced with glass fiber sheet. Four types of specimen — self-curing resin plate (R) , light-curing oligomer plate containing a reinforcement (GO) , and self-curing resin plate containing a reinforcement on one (GR) or both (GRG) sides — were prepared with three thicknesses: ...

To investigate the influence of carbon fiber (CF) surface treatment on the flexural strength and tribological properties of the short-cut CF/polyimide (PI) composites, pitch-based short-cut CF were treated by rare earth. The CF before and after treatment was examined by X-ray photoelectron spectroscopy (XPS) and by scanning electron microscopy (SEM). The flexural strength of the specimens was d...

Objective: To evaluate the influence of the surface used for manipulation (paper block and glass slab) on the mechanical properties (flexural strength and elastic modulus) and ion release (F) of two resin modified glass ionomer cements (RMGIC). Methods: Two RMGICs: Vitro Fil LC (DFL) and Riva Light (SDI) were used. The materials were manipulated on two different surfaces: block of paper and gla...

Introduction: It may be necessary to make some modifications to the removable space maintainers for the persuasion of children to use this device. However, modification of the polymethyl methacrylate (PMMA) may affect its mechanical properties as well. Therefore, the present study aimed to evaluate the effects of color and glitter on the flexural strength of  PMMA. Meth...