To determine the potential of a low cost Irish engineered timber product to replace high cost solid timber for use in bending active structures such as gridshells a single Irish engineered timber product in the form of orientated strand board (OSB) was selected. A comparative study of OSB and solid timber was carried out to determine the optimum properties that make a material suitable for use ...

Fatigue life estimation is one of the most important design considerations in mechanical parts which are subjected to alternating loads. When loads act along several axes, multiaxial fatigue approach should be used to obtain more accurate results than uniaxial fatigue method. In this paper stress analysis of the steel shaft of a high speed microgenerator rotor with 47750 rpm and 100kW is carrie...

The aim of this study was to determine a suitable amount of grinding of a flexural test specimen for clinical evaluation of dental ceramics. Three dental ceramics (Crys-Cera, OCC and IPS Empress Cosmo) were selected. Five types of bar-shaped patterns were prepared for a three-point bending test, and four types of disk-shaped patterns for a biaxial flexural test. Ceramic specimens were fabricate...

Objectives The purpose of this experimental study was to discover a method to increase the strength of repaired polymethyl methacrylate (PMMA) samples. Materials and Methods In this experimental study, 40 specimens with the dimensions of 65×10×2.5mm3 were fabricated using heat-curing acrylic resin. Sixteen specimens were repaired with fiberglass and self-curing PMMA, while 16 samples were rep...

The choice of the most suitable orthodontic wire for each stage of treatment requires estimation of the forces generated. In theory, the selection of wire sequences should initially utilize a lower flexural rigidity; thus clinicians use smaller round cross-sectional dimension wires to generate lighter forces during the preliminary alignment stage. This assessment is true for conventional alloys...

The purpose of this study was to evaluate the effects of the silane coupling agent amount on the flexural properties and hydrolytic durability on an experimental composite resin for understanding the optimum amount of silanation. A spherical filler was silanated with 7 different amounts of gamma-MPTS, 0, 0.17, 0.34, 0.66, 1.36, 2.72 and 5.45 mass%. Photopolymerized experimental composite resins...

The Welding in cold formed areas is not only an open question for statically loaded sections (brittle fracture) but also for dynamically loaded structures (fatigue resistance). A lot of structures are subjected to dynamic loadings and unfortunately very little information about the influence of welding in the cold formed areas on fatigue resistance is available. In order to establish the fatigu...

INTRODUCTION: Mechanical analogue composite bone models have been used as cadaveric bone substitutes in a wide variety of biomechanical tests. The objective of this study was to validate the diaphyseal structural properties in terms of flexural rigidity, ultimate bending strength, axial stiffness, ultimate compression strength, ultimate torsional strength, torque angle at ultimate torsional str...

Purpose: The purpose of this paper was to find relationship between the degree of strength degradation caused by fatigue and the changes of ultrasonic wave characteristics such as wave velocity and damping coefficient. Design/methodology/approach: Epoxy-glass composites were subjected to oscillatory bending loadings with constant deflection. During fatigue procedure the force needed to achieve ...

We report on the mechanical fatigue behavior of printed, organic, thin-film transistors (OTFTs) based on a polymer semiconductor, investigated by repeatedly applying strain to the flexible OTFT devices and assessing their electrical characteristics after 60,000 bending cycles. As part of our investigation, we established that the rates of reduction in source/drain currents in the OTFT device de...