Polymer-derived ceramics (PDCs) such as silicon oxycarbide (SiOC) have shown promise as electrode materials for rechargeable Li-ion batteries (LIBs) owing to the synergy between their disordered carbon phase and hybrid bonds of silicon with oxygen and carbon. This study describes the synthesis and characterization of a new type of PDC composite comprising SiOC embedded with varying wt% of boron...

The two-dimensional (2D) transition metal dichalcogenide nanosheet-carbon composite is an attractive material for energy storage because of its high Faradaic activity, unique nanoconstruction and electronic properties. In this work, a facile one step preparation of a molybdenum disulfide (MoS2) nanosheet-graphene (MoS2/G) composite with the in situ reduction of graphene oxide is reported. The s...

The composite metal oxide electrode films were fabricated using ex situ electrodeposition method with further heating treatment at 300°C. The obtained composite metal oxide film had a spherical structure with mass loading from 0.13 to 0.21 mg cm(-2). The structure and elements of the composite was investigated using X-ray diffraction (XRD) and energy dispersive X-ray (EDX). The electrochemical ...

Tracking the dynamic morphology of active materials during operation of lithium batteries is essential for identifying causes of performance loss. Digital volume correlation (DVC) is applied to high-speed operando synchrotron X-ray computed tomography of a commercial Li/MnO2 primary battery during discharge. Real-time electrode material displacement is captured in 3D allowing degradation mechan...

Wire electrical discharge machining (WEDM) is a method to cut conductive materials with a thin electrode that follows a programmed path. The electrode is a thin wire. Typical diameters range from .004" - .012" (.10mm - .30mm) although smaller and larger diameters are available. WEDM is a thermal machining process capable of accurately machining parts with varying hardness or complex shapes. WED...

Wire electrical discharge machining (WEDM) is a method to cut conductive materials with a thin electrode that follows a programmed path. The electrode is a thin wire. Typical diameters range from .004" - .012" (.10mm - .30mm) although smaller and larger diameters are available. WEDM is a thermal machining process capable of accurately machining parts with varying hardness or complex shapes. WED...

Migration of ions under electric field is the phenomenon behind the mechanical deformation of ionic polymer actuators. This transport process is influenced by numerous factors depending on the physical, chemical and electrical properties of the material used [1]. Among them porosity and tortuosity are one of the main influencing factors that modifies ion channels and so the properties of the ma...

We report electrowetting on dielectric (EWOD) experiments using graphene; a transparent, flexible and stretchable nanomaterial. Graphene sheets were synthesized by chemical vapor deposition, and transferred to various substrates (including glass slides and PET films). Reversible contact angle changes were observed on the Teflon-coated graphene electrode with both AC and DC voltages. Nyquist plo...

In this study, to fabricate a carbon free (C-free) air electrode, Co3O4 nanofibers were grown directly on a Ni mesh to obtain Co3O4 with a high surface area and good contact with the current collector (the Ni mesh). In Li-air cells, any C present in the air electrode promotes unwanted side reactions. Therefore, the air electrode composed of only Co3O4 nanofibers (i.e., C-free) was expected to s...

Dielectric: materials commonly used as insulators in spark gaps (Lexan, Nylon, Lucite, Macor, Boron Nitride, Delrin and G-10) have been exposed to the by-products of arcs in three different spark gap experiments. The first was a 60 kV, 0.05 Caul/shot spark gap using copper-tungsten or graphite electrodes at various pressures of N2 or SF6 gas. The second was a 5-30 kV, 4-25 kA, .l-.6 Coul/shot, ...