The austenitic stainless steel (SS) has been used as a material for  building  ultra  high  vacuum  (UHV)  chamber.  Recently significant  efforts  have  been  concerned  a  comparing  the standard  cleaned  for  ultra  high  vacuum,  passivity  stainless. In  this work Austenitic  nanocomposites were  synthesize by sol-  gel method. The morphologies  and  topographies  of  the samples  h...

Titanium nitride thin films were grown on 304 stainless steel substrates at various nitrogen/argon flow ratios by ion beam sputtering (IBS) technique. The current research is a follow up study on the influence of gas ratio on structural and corrosion properties in the TiN coated 304 stainless steel. Film structural identification of phases was performed using X-ray diffractometry (XRD). Sca...

Laboratory-based diffraction contrast tomography (DCT) was applied to heat-treated lean duplex stainless steel (DSS) observe microstructural changes by hydrogen infusion treatment. The feasibility of the DCT technique for in situ assessment a dual-phase material with exposure aqueous solution investigated, observations carried out before and after cathodic charging. movement spots observed char...

Initiation of corrosion on reinforcing bars occurs when a critical chloride concentration is achieved. A universal value for the chloride concentration that causes depassivation has not been agreed upon for carbon steels due to a variety of experimental factors. The chloride threshold depends on the rebar material, rebar surface condition, testing environment, method of detection, definition of...

This paper presents a study to evaluate the mechanical properties of commercially available GRP composite fasteners for the fairing band assembly components of the hull mounted sonar domes on Canadian frigates. The study was undertaken as part of an effort to develop an all-composite fairing band assembly for a stainless steel sonar dome, to eliminate corrosion problems that occur with the use ...

Introduction: During sliding mechanics, frictional resistance is an important counterforce to orthodontic tooth movement; which must be controlled to allow application of light continuous forces. objective: To investigate static and kinetic frictional resistance between three orthodontic brackets: ceramic, self-ligating, and stainless steel, and three 0.019×0.025” archwires: stainless steel, ni...