We have carried out an experimental and in silico investigation of path selection by a single droplet inside a tertiaryjunction microchannel using oil-in-water as a model system. The droplet was generated at a T-junction inside a microfluidic chip and its flow behaviour as a function of droplet size, streamline position, viscosity, and Reynolds number (Re) of the continuous phase was studied do...

The He(n)(+)/He(2)(+) (n ≥ 3) signal ratios in the mass spectra derived from electron impact ionization of pure helium nanodroplets are shown to increase with droplet size, reaching an asymptotic limit at an average droplet size of approximately 50,000 helium atoms. This is explained in terms of a charge hopping model, where on average the positive charge is able to penetrate more deeply into t...

Purpose: To perform stability studies on a nanoemulsion formulation containing beclomethasone dipropionate (BD) and prepared by spontaneous emulsification method. Method: A nanoemulsion (o/w) containing BD was prepared using eucalyptus oil, Tween-40, ethanol and distilled water. The nanoemulsions were characterized by droplet size, pH, viscosity, conductivity and refractive index. Stability stu...

Two basic methods have been used to relate the change in droplet number concentration to aerosol number concentration. The first method uses empirically derived relationships based on either observed aerosol number concentrations and droplet concentrations or observed aerosol sulfate or droplet mass concentrations and droplet number concentrations. This method was followed by Jones et al. (1994...

We consider the finite-size scaling of equilibrium droplet shapes for fluid adsorption (at bulk two-phase coexistence) on heterogeneous substrates and also in wedge geometries in which only a finite domain Λ A of the substrate is completely wet. For three-dimensional systems with short-ranged forces we use renormalization group ideas to establish that both the shape of the droplet height and th...

We have demonstrated the application of low surface energy fluoropolymer coatings onto poly(dimethylsiloxane) (PDMS) microfluidic devices for droplet formation and extraction-induced merger of droplets. Initiated chemical vapor deposition (iCVD) was used to pattern fluoropolymer coatings within microchannels based on geometrical constraints. In a two-phase flow system, the range of accessible f...

Droplet formation in the presence of nanoparticles was studied in a T-shaped microfluidic device numerically. Nanoparticles in continuous phase did not influence droplet formation dynamics obviously. Contrarily, the presence of nanoparticles in dispersed phase will influence evidently droplet formation dynamics, likely reasons are the accumulation of nanoparticles at the liquid-liquid interface...

Nanotechnology, shortened to nanotech, is the study of the controlling of matter on an atomic and molecular scale. Generally, nanotechnology deals with structures sized between 1 to 100 nanometer in at least one dimension and involves developing materials or devices within that size. The use of nanotechnology in the field of pharmaceutics and drug delivery has grown over the last few years, so ...

New methodologies are required to probe the sensitivity of parameters describing cloud droplet activation. This paper presents an inverse modeling-based method for exploring cloud-aerosol interactions via response surfaces. The objective function, containing the difference between the measured and model predicted cloud droplet size distribution is studied in a two-dimensional framework, and pre...

benign prostatic hyperplasia (bph) is the most common condition in aging men, associated with lower urinary tract symptoms. it is caused due to the augmented levels of the androgen dihydrotestosterone. dutasteride, a 5α-reductase inhibitor has been recommended for the treatment of bph upon oral administration. however, long term oral administration of dutasteride may cause sexual problem in man...