Aiming at the non-stationary and stall flutter problems of wind turbine blade caused by transient load fluctuations, the dynamic properties of wind turbine were studied, the blade was simplify to a cantilever beam in case of the action of shear deformation and cross section rotating effect were considered in this analysis, equations of the blade were established based on D'Alemberts' principle ...

A mathematical model for enhancing the torsional stability of a slender, tapered, composite wind turbine blade is presented. The increase of the stability boundary is measured by maximization of the critical wind speed at which failure may occur by aeroelastic divergence in parked-turbine state. The total structural mass of the blade is kept constant in order not to violate other economic and p...

The objective of this research is to develop a turbine blade investment casting cost advisor model to assist a blade designer in decision-making in a concurrent engineering environment. It is a microcomputer based cost estimating system that employs a manufacturing knowledge base. The concept of the manufacturing process for blade production by the investment casting method is used to develop t...

the machine to be designed and developed with a view to resolve one ofthe irksome problems of this institute has been facing every year. this institute issurrounded by vast non- fertile land area of about 200 acres, which becomes widelyoccupied by numerous breads of bushes and shrubs during post-rainy season. due tothis unwanted proliferation of such verdant institute gets abysmal look and that...

The material properties of food can exert a significant influence on tooth morphology. Although the stiffness or toughness of a material is usually of prime concern, other aspects of material properties (such as extensibility) can be of equal importance. Previous experimental work on the effect blade shape has on fracturing biological materials indicated a notched blade greatly reduced the work...

This study investigated the mechanical properties of a new rectangular compaction blade and compared this blade with other types of nail. Three types of nail were tested: the Magnum lag screw (Robert Reid Inc, Tokyo, Japan), proximal femoral nail, and Magnum Fid blade (Robert Reid Inc). The nails were inserted into solid rigid polyurethane foam, and the torsional moments were loaded with an Ins...

The blade is one of the most critical parts of an aviation engine, and a small change in the blade geometry may significantly affect the dynamics performance of the aviation engine. Rapid advancements in 3D scanning techniques have enabled the inspection of the blade shape using a dense and accurate point cloud. This paper proposes a new method to achieving two common tasks in blade inspection:...

The results from two numerical simulations of the unsteady flow in a 1-1/2 stage axial-flow turbine are presented and compared with experimental data to show both the effect of blade count on the solution accuracy and the time-averaged and unsteady flow physics present. The TFLO three-dimensional, multi-block, massively parallel turbomachinery flow solution procedure is used to simulate the flo...

Rotor blade injuries are an inherent hazard of helicopter operations. To determine the recent incidence of rotor blade injuries in the U.S. Army, a review of accident records (1972-91) was conducted. Crash-related injuries were not included. During the study period, there were 24 blade strike injuries (12 involving the main rotor), 11 (46%) of which were fatal. Comparison with previous reports ...