hot rolling of a large ring of titanium alloy (lrt) is a highly nonlinear incremental forming process with coupled mechanical and thermal behaviors (mtbs) which significantly affect microstructure and properties of the ring. the feed rate of idle roll and the rotational speed of driver roll have major effects on ovality of the ring. in this paper, the effects of these parameters on the ovality ...

The dimpling process is a novel cold-roll forming process that involves dimpling of a rolled flat strip prior to the roll forming operation. This is a process undertaken to enhance the material properties and subsequent products' structural performance while maintaining a minimum strip thickness. In order to understand the complex and interrelated nonlinear changes in contact, geometry and mate...

By examining the absolute magnitude (H) distributions (hereafter HD) of the cold and hot populations in the Kuiper belt and of the Trojans of Jupiter, we find evidence that the Trojans have been captured from the outer part of the primordial trans-Neptunian planetesimal disk. We develop a sketch model of the HDs in the inner and outer parts of the disk that is consistent with the observed distr...

Warm inflationary dynamics is shown to satisfy both the slow-roll and density perturbation constraints for mφ ≫ H or equivalently η ≫ 1 and for inflaton field amplitudes much below the Planck scale, 〈φ〉 < mpl. I start by reviewing the two types of inflation dynamics, isentropic or cold inflation and nonisentropic or warm inflation. In the former, inflation occurs without radiation production, w...

In this article, we present a critical review of the swimming literature on body roll, for the purposes of summarizing and highlighting existing knowledge, identifying the gaps and limitations, and stimulating further research. The main research findings can be summarized as follows: swimmers roll their shoulders significantly more than their hips; swimmers increase hip roll but maintain should...

An Al/Stainless Steel/Al lamellar composite was produced by roll bonding of the starting sheets at 400 °C. Afterward, the roll bonded sheet was cut in half and the accumulative roll bonding (ARB) process at room temperature was applied seven times. As a result, the central steel layer fractured and distributed in the Al matrix among different layers introduced by the repetition of roll bonding ...

In order to automate the scooping task, it is desirable that the resistive force acting on the bucket be obtained before the scooping is performed. The objective of this study is to derive theoretically the resistive forces acting on the bucket during scooping of piled rock fragments. First, the changes in the shape of the rock pile due to the penetration of it by the bucket are modeled. Based ...

Analytical models for channel potential, threshold voltage, and subthreshold swing of the short-channel fin-shaped field-effect transistor (FinFET) are obtained. The analytical model results are verified against simulations and good agreements are observed. Analytical expressions for subthreshold swing, drain induced barrier lowering effect, and threshold voltage roll-off characteristics are pr...