Many years of experience in several industries have shown that the use of wastes as alternative fuels in cement plants is both ecologically and economically justified. However, there are several factors that need assessment before using alternative fuels. Further, availability and cost are important factors too. Along with other alternative fuels, literature and case studies have revealed that ...

pulpal health, waiting for gingival healing from periodontal and oral surgery, waiting for implants to integrate, and evaluating aesthetic and functional changes, to name a few. Some of the clinical requirements of provisional cements are: (1) good retention – it is desirable to have enough retention for long-term provisional cementation, yet not be so retentive that is difficult to remove the ...

Department of Operative Dentistry, Faculty of Dentistry, Chulalongkorn University, Bangkok, Thailand, Cariology and Operative Dentistry, Department of Restorative Sciences, Graduate School, Division of Conservative Dentistry, GKT Dental Institute, London, United Kingdom, and Center of Excellence Program for Frontier Research on Molecular Destruction and Reconstruction of Tooth and Bone, Tokyo M...

Both clays and calcium silicate hydrates(the main hydration products of Portland cements) exhibit a microstructure made up of lamellar particles. The microscopic mechanism responsible for the macroscopic creep of such materials is often described as the relative sliding of the sheets. This paper proposes a micromechanical approach to estimate the macroscopic creep behavior rising from this micr...

The activity concentrations of (226)Ra, (232)Th and (40)K in seven brands of Portland cement used in Nigeria have been determined using a gamma-ray spectrometer with a hyperpure germanium detector. A total of 22 samples were collected from suppliers. The mean activity concentrations varied between 19.2 and 85.1 Bq kg(-1), 12.9 and 31.7 Bq kg(-1), and 31.5 and 116 Bq kg(-1) for (226)Ra, (232)Th ...

Labial cavities in vervet monkeys were filled with two luting cements and 2 control materials (negative and positive). Specimens were recovered and examined histo­ logically. There war little difference between the pulpal reactions to the 4 materials. The reactions to the two test materials (luting cements) are, in 28 and 56 day spec­ imens, not more severe than the reactions to the negative co...

OBJECTIVES In an assessment of the risk of asbestos fibres release from asbestos cement materials, an important role is played by the assessment of the surface corrosion and by the disaggregation of asbestos cement. The aim of this work is to evaluate the differences among several methods used for the risk assessment that lead to a specific choice of abatement techniques. METHODS The state of...

A survey was conducted to ascertain the variations practiced in powder/liquid (P/L) ratio of Glass Ionomer Cement (GIC) used as restorative and luting material in dental clinics of Karachi. It has been observed that in the use of GIC brands, 33% (Fuji 2) and 36% (Gold Label 2) of the dentists, did not follow the recommended P/L ratios for restorative purposes. Similarly, 67% (Fuji 1) and 29% (G...

This present study investigated the effects of the addition of hydroxyapatite (HA) on the flexural strength and microstructure of conventional GIC, and its effect on the cement's initial flexural strength at different storage conditions. Specimens were fabricated by mixing HA in whisker or granule form into commercially prepared GIC, and these were subjected to a three-point bending test and SE...

The purpose of this study was to investigate the reuse of desulfurization slag in cement clinker production and its influence on the formation of clinker phases. The desulfurization slag that mainly contained Ca and Si was identified as non-toxic, and thus it should be suitable to be reused in clinker production. The addition of desulfurization slag increased the melt phase during clinkerizatio...