Aladin is an expert system that aids metallurgists in the design of new aluminum alloys. Declarative structured representations in the form of schemata are used for metallurgical data and concepts. The representation is very general, the goal has been to create a representation for all knowledge about aluminum alloys and metallurgy relevant to the design process. This article gives an overview ...

Commercial, aluminum die-cast alloys are subject to long-term stresses leading to viscoelastic material responses resulting in inefficient engine operation and failure. Constant load creep tests were conducted on aluminum die-casting alloys: B-390, eutectic Al-Si and a 17% Si-Al alloys. Rupture occurred in the primary creep regime, with the eutectic alloy having the longest times to failure. Pr...

Aluminum coating was prepared on AZ91D magnesium alloy substrate using the electrophoretic deposition (EPD) method in absolute ethanol solvent. In order to determine the optimal concentration of AlCl3.6H2O additive, the zeta potential and size of particles in the suspension were measured in the presence of different concentrations of AlCl3.6H2O. The results showed that an appropriate coating is...

In this study, the effects of heat treatment of aluminum alloy on the tube bending process were investigated in the rotary draw bending process. As two experimental and numerical simulation methods were used to determine the wall-thinning, ovality, and spring back for extruded, annealed, and aged AA6063 aluminum alloy tubes in different bending angles and bend radii. Numerical simulations were ...

According to the deformation and movement requirements of the FAST reflector, a multipurpose analysis, including the load-bearing behavior, deformation, construction costs of the reflector supporting structure and its model, is presented in this paper. The advantages and disadvantages of steel and aluminum alloy structures are also discussed and compared through detailed design calculations und...

In this paper, a characterization of an AlSiMg alloy processed by direct metal laser sintering (DMLS) is presented, from the analysis of the starting powders, in terms of size, morphology and chemical composition, through to the evaluation of mechanical and microstructural properties of specimens built along different orientations parallel and perpendicular to the powder deposition plane. With ...

ABSRACT A comparative study of the surface microstructural changes after fatigue in an ultrafine grained and coarse grained aluminum alloy was performed using orientation imaging microscopy (OIM). The fraction of low angle boundaries with misorientation less than 2.5 ̊ increased for both the coarse and ultrafine grained alloys. A consistent decrease in the fraction of low angle boundaries, with ...

Technology of round bars rolling on a three-high skew rolling mills allows rolling of standard materials such as steel and aluminum, as well as new materials, especially hard deformable materials. The paper presents the results of theoretical and experimental rolling process of aluminum bars with a diameter of 20 mm. As the stock round bars with a diameter of 25 mm made of aluminum grade 1050A ...

The second-generation aluminum-magnesium-scandium (Al-Mg-Sc) alloy, which is often referred to as Scalmalloy®, has been developed as a high-strength aluminum alloy for selective laser melting (SLM). The high-cooling rates of melt pools during SLM establishes the thermodynamic conditions for a fine-grained crack-free aluminum structure saturated with fine precipitates of the ceramic phase Al₃-Sc...

The present paper aims to investigate the solidification behavior and the forgeability of Aluminum alloy (LM6)-SiCp composites at different section of three-stepped composite castings. The temperature of the cast composites during solidification has measured by putting K-type thermocouples at the center of the each step/section, from which the solidification curves were constructed. The forgeab...