In this study, the synergistic effects of abrasion and corrosion on AISI 316L stainless steel have been investigated using a micro-abrasion test rig. A series of results from abrasioncorrosion tests conducted using the micro-abrasion rig are presented. AISI 316L stainless steel has been studied under both pure abrasion and abrasion-corrosion conditions simulated by either distilled water or 3.5...

In this present work, The effect of input parameters viz. grinding wheel speed, work-piece speed, abrasive grain size, depth of cut, concentration of cutting fluid, and number of passes has been found on the surface roughness of cylindrical grinded AISI 4140 steel has been found. The other parameters like feed rate, diameter of work-piece, coolant flow rate, etc. are kept constant. Three levels...

Characteristics of tempered martensite embrittlement (TME), hydrogen embrittlement (HE), and stress corrosion cracking (SCC) in high-strength steels are reviewed. Often, it is important to determine unambiguously by which of these mechanisms failure occurred, in order to suggest the right actions to prevent failure recurrence. To this aim, samples made of high-strength AISI 4340 alloy steel wer...

This paper presents experimental results of wear process under dry and boundary lubricated metallic (AISI 1034/AISI 52100) contacting bodies with different surfaces morphologies subjected to a wide range of kinematic fretting conditions. Analysis of damage mode observed under such fretting conditions is elucidated in context of surfaces morphologies therefore associated with surface manufacturi...

An ultra-fine-grained AISI 301LN austenitic stainless steel has been achieved by heavy cold rolling, to induce the formation of martensite, and subsequent annealing at 800 C, 900 C, and 1000 C, from 1 to 100 seconds. The microstructural evolution was analyzed using transmission electron microscopy and the yield strength determined by tension testing. Ultra-fine austenite grains, as small as ~0....

Pitting corrosion was observed on a high purity Fe-17Cr alloy in 0.02M NaCl solution of pH 6.6 at high anodic potential (+ 550 mVISCE). Potentiostatic electrochemical noise measurements were performed, revealing the presence of a characteristic current noise below stable pitting, differing strongly from that observed 011 a series of AISI 430 type 17% Cr stainless steels, with respect to the fre...

In this paper, we have addressed the Design and simulation results of an electrostatically controlled micro mirror using COMSOL multiphysics Software. The structural mechanical properties of the actuation mechanism of a square shape micro-mirror with the lift-off of the structure used four springs simulating a prestressed cantilever beam. There are few base materials were introduced like Alumin...

This article describes fretting behavior of zirconia and silicon nitride balls on an electro-deposited coating. Fretting tests are performed using a ball-on-flat configuration. The evolution of the kinetic friction coefficient is determined, along with slip ratio. Experimental results show that the steady-state friction coefficient between ceramic balls (Si₃N₄ and ZrO₂) and an electro-deposited...

The present work is concentrated with the dry turning of AISI 304 Austenitic Stainless Steel (ASS). This paper presents the influence of cutting parameters like cutting speed, feed rate and depth of cut on the surface roughness of austenitic stainless steel during dry turning. A plan of experiments based on Taguchi’s technique has been used to acquire the data. An orthogonal array, the signal t...

The aim of this study is to investigate experimentally the microstructural evolution of the joints using ledeburitic AISI D2 Tool Steel parts. The application of a new process of the semisolid joining of two parts of AISI D2 cold-work tool steel is proposed using a partial remelting method. Samples were heated in an argon atmosphere up to 1300°C and held for 10 minutes. Metallographic analyses ...