In this paper the radial deformation and the corresponding stresses in a functionally graded orthotropic hollow cylinder with the variation in thickness and density according to power law and rotating about its axis under pressure is investigated by using Seth's transition theory. The material of the cylinder is assumed to be non-homogeneous and orthotropic. This theory helps to achieve better ...

In this paper, an analytical solution for computing the linear plastic stresses and critical pressure in a FGM hollow cylinder under the internal pressure due to non-Axisymmetric Loads is developed. It has been assumed that the modulus of elasticity was varying through thickness of the FGM material according to a power law relationship. The Poisson's ratio was considered constant throughout the...

in this study, the characteristics of the wake around a rotating circular cylinder have been investigated experimentally. to this end, a cylinder with a circular cross-section of plexiglas with the length of 400 mm and a diameter of 20 mm have been tested in the wind tunnel. using existing methods, the characteristics of the wake and the drag coefficients of the model in different cases have be...

1.6L OHV “KENT” ENGINE Open-wheel racing enthusiasts associate this overhead valve design with the long-lived international Formula Ford series, the starting point for many professional drivers. Most of the combustion chamber is in a dished piston, where the mating cylinder head face is nearly flat. Production for European models (Cortina, Capri and Fiesta) is now phased out. Ford Racing sold n...

We study one of the central open questions in one-dimensional renormalization theory – the conjectural universality of golden-mean Siegel disks. We present an approach to the problem based on cylinder renormalization proposed by the second author. Numerical implementation of this approach relies on the Constructive Measurable Riemann Mapping Theorem proved by the first author. Our numerical stu...

An experimental study was conduct to suppress the vortex shedding from a circular cylinder by using a suction flow control method. The suction flow control was accomplished using two suction holes located on the test cylinder model at an angle of 90.0 degrees in relation to the oncoming flow direction. In addition to measuring the pressure distributions around the test model, a high-resolution ...

BOG (Boil off Gas) compressor deals with the gas evaporated from the LNG storage tank. Its working temperature is lower than-120℃. There are two types of starting process for BOG compressor: Direct Starting and No-load Starting. During the starting process, the temperature on cylinder will change rapidly and result in additional thermal stress to some parts on the cylinder, especially to the bo...

PURPOSE A primary task of the eye care professional is determining the refraction, or optical correction, of a patient. The duochrome red-green test is a standard tool for verification of the final refraction. Traditionally, it is recommended for use both prior to and subsequent to determining the cylindrical or astigmatic component of the refraction. In order for it to be effective when used b...

Abstract In this study, the optical diagnostics techniques of infrared (IR) absorption and chemiluminescence were applied to a racing engine. A small M5 IR sensor and Cassegrain optics sensors were developed to measure in-cylinder fuel concentrations and local chemiluminescence intensities. The small IR sensor was able to withstand racing engine operating conditions up to 16,000 rpm and exhibit...

INTRODUCTION In scuba-diving practice, instantaneous gas consumption is generally calculated from the fall in cylinder pressure without considering the effects of water temperature (heat transfer) and adiabatic processes. We aimed to develop a simple but precise method for calculating the instantaneous gas consumption during a dive. METHODS With gas thermodynamics and water/gas heat transfer,...