[1] Hydraulic tomography, a procedure involving the performance of a suite of pumping tests in a tomographic format, provides information about variations in hydraulic conductivity at a level of detail not obtainable with traditional well tests. However, analysis of transient data from such a suite of pumping tests represents a substantial computational burden. Although steady state responses c...

Steady-state and transient experiments of water–gas, oil–water and oil–water–gas multiphase flows were conducted on a transparent 11 m long, 15 cm diameter, inclinable pipe using kerosene, tap water and nitrogen. The pipe inclination was varied from 0 (vertical) to 92 and the flow rates of each phase were varied over wide ranges. Fast-acting valves enabled the trapping of the fluid flowing in t...

A new variant of MEMS surface fence is proposed for shear-stress estimation under high-speed, high-temperature flow conditions. Investigation of high-temperature resistance including heat-resistant mechanism and process, in conjunction with high-temperature packaging design, enable the sensor to be used in environment up to 400 °C. The packaged sensor is calibrated over a range of ~65 Pa and th...

Sediment transport under unsteady flow condition is studied experimentally. In the first step, sediment transport under different steady flow conditions was measured and an empirical equation was derived for its calculation. In the next step, two continuous and three stepwise hydrographs were generated in the flume, and their sediment transport rate was measured. The continuous hydrographs were...

The aim of this paper is the steady state and dynamic simulations of the ammonia unit of Shiraz petrochemical complex and system behavior study versus the feed flow rate change for producing a good quality product. The ammonia unit consists of the reformer units, shift converter units, carbon dioxide absorption unit, methanation unit, and ammonia synthesis unit. For this purpose, in the first s...

Unlike systems of batch analysis, continuous flow systems possesskinetic parameters. Associated with the steady state are such measurements as noise level and drift. This study reports on kinetic parameters associated with the transient state between the steady states including time required to change from base-line steady state to sample steady state and vice versa, characteristics of this cha...

In the present study, the transient stress distribution caused by a break in the fibers of an adhesive bonding is investigated. Transient stress is a dynamic response of the system to any discontinuity in the fibers from detachment time till their equilibrium state (or steady state). To derive the governing dynamic equilibrium equations shear lag model is used. Here, it is assumed that the tens...

Turbulent flow in the continuous casting process involves transient phenomena and the transport of inclusion particles and plays an important role in the quality of the steel. As shown in Fig. 1, the molten steel jet entering the mold may carry inclusion particles (e.g. alumina) and argon bubbles. Liquid flux can also be entrained from the shear of the liquid flow across the top surface and for...