The experimental investigation on cutting tool wear and a model for tool wear estimation is reported in this paper. The changes in the values of cutting forces, vibrations and acoustic emissions with cutting tool wear are recoded and analyzed. On the basis of experimental results a model is developed for tool wear estimation in turning operations using Adaptive Neuro fuzzy Inference system (ANF...

A cold sprayed Al coating on S355 structural steel was processed using a laser remelting (LR). The surface and cross-section morphologies, chemical compositions, and phases of as-obtained Al coating before and after LR were analyzed using a scanning electronic microscope (SEM), energy dispersive spectrometer (EDS), and X-ray diffractometer (XRD), respectively, and their hardness was measured us...

Complications involving the patellofemoral joint, caused by malrotation of the femoral component during total knee replacement, are an important cause of persistent pain and failure leading to revision surgery. The aim of this study was to determine and quantify the influence of femoral component malrotation on patellofemoral wear, and to determine whether or not there is a difference in the ra...

The introduction of numerous formulations of Ultra-high molecular weight polyethylene (UHMWPE), which is widely used as a bearing material in orthopedic implants, necessitated screening of bearing couples to identify promising iterations for expensive joint simulations. Pin-on-disk (POD) testers capable of multidirectional sliding can correctly rank formulations of UHMWPE with respect to their ...

Ultralow wear nature of gallium nitride (GaN) has been revealed recently. The wear rate for GaN has a significant dependence on humidity, ranging from 9 10 9 mm3/Nm to 9.5 10 7 mm3/Nm; the mechanisms responsible for this variation in wear remain unclear. Here, we performed reciprocal sliding test on GaN under different environments and characterized the chemical compositions of corresponding wo...

STATEMENT OF PROBLEM Computer-aided design and computer-aided manufacturing (CAD/CAM) resins exhibit good mechanical properties and can be used as long-term restorations. The wear rate of such resins and their enamel antagonists is unknown. PURPOSE The purpose of this study was to test and compare the 2-body wear rate of CAD/CAM resin blocks. MATERIAL AND METHODS Wear specimens (N=42, n=6) ...

With recent improvements to the properties of ultra-high molecular weight polyethylene (UHMWPE) used in joint replacements, prosthetic knee and hip longevity may extend beyond two decades. However, it is difficult and costly to replicate such a long in vivo lifetime using clinically relevant in vitro wear testing approaches such as walking gait joint simulators. We advance a wear test intermedi...

AIMS The purpose of this study was to assess the prevalence of tooth wear, symptoms of reflux and salivary parameters in a group of patients referred for investigation of gastro-oesophageal reflux disease (GORD) compared with a group of control subjects. MATERIALS AND METHODS Tooth wear, stimulated salivary flow rate and buffering capacity and symptoms of GORD were assessed in patients attend...

In finish-machining, geometric accuracy and surface quality m adversely affected by the tool wear at the minor flank and nose area. This paper describes an investigation into "comprehensive" tool wear estimation, including flank-, crater-. minor flank-, and nose-wear, based on an analysis of dynamic cutting force in oblique machining. The force, measured in terms of its three orthogonal compone...

Carbon fiber reinforced plastics (CFRP) have good physical properties, such as high specific strength and high specific modulus. However, cutting delamination, tearing and burr, etc. often occur in the machining process of CFRP, which results in the uncontrollability of machining surface quality and serious tool wear. In this paper, milling of CFRP with a staggered cutter was carried out, the c...