Broken rotor bars and end-ring are common faults in three-phase squirrel-cage induction motors. These faults reduce the developed toque and increase the speed fluctuations of the motor. Meanwhile, developed unsymmetrical magnetic generates noise and vibration in the motor. Local heat around the broken bars may gradually break the adjacent bars and the motor will be finally out of service. Finit...

In general, the conventional techniques like loop impedance and nodal admittance methods are used to find the parameters of SEIG for finding performance under various conditions. In these approaches, long mathematical calculations are involved. With the recent development, ANN and fuzzy logic are used for finding various parameters for different values of machine parameters. By finding these pa...

Many control schemes have been proposed for induction motor and permanent magnet synchronous motor control, which are almost highly complex and non-linear. Also, a simple and efficient method for unified control of the electric moto are rarely investigated. In this paper, a novel control method based on rotor flux orientation is proposed. The novelties of proposed method are elimination of q-ax...

In order to harness the kinetic energy of marine currents, we propose a novel ocean-current turbine with a horizontal axis. The turbine can be moored to the seabed and function similarly to kites in a water flow. To operate such turbines in a marine current, the resulting rotor torque needs to be canceled. Therefore, the proposed turbine is designed with a float at its top and a counterweight a...

This study examined and presents an effective method for detection of failure of conductor bars in the winding of rotor of induction motor in low load conditions using neural networks of radial-base functions. The proposed method used Hilbert method to obtain the stator current signal push. The frequency and signal amplitude of the push stator were used as the input of the neural network and th...

In this paper, a new method is proposed for the speed control of a three-phase current forced synchronous machine drive. This metohd is based on the use of an approximate constant commutation safety margin angle in the output thyristor bridge of the drive system as well as on the compenastion of stator magnetization reaction. The commutation process in the output converter of the machine driv...

The paper presents a super-twisting sliding mode (STSM) regulator with neural networks (NN) of direct power command (DPC) for controlling the active/reactive power of a doubly-fed induction generator (DFIG) using a two-level space vector pulse width modulation (2L-SVPWM). Traditional DPC strategy with proportional-integral (PI) controllers (DPC-PI) has significantly more active/reactive power r...

This paper presents a novel sensorless control method of permanent magnet synchronous motors at standstill and low speed based on a low-frequency current signal injection. The approach superimposes a persistent LF current signal into the estimated d-axis to get the rotor position error angle-related signal by detecting the corresponding voltage response and current response. Then the rotor posi...

This paper presents the performances evaluation of different wavelet transform under broken rotor bars fault diagnosis. In this report, stator phase current was used for wavelet analysis. Discrete wavelet transform (DWT) coefficients of stator current in a specific frequency band are derived and analyzed. Wavelets db8, db9, db10, sym7 and sym8 are employed to analyze broken bar distorted stator...

In the present paper a simple sensorless spccd estimation scheme is presented , where the speed information is obtained from the motor phase current ripple. The scheme measures the stator current phasor deviation direction to determine the back emf vector position during inverter zero vector switching states. This measurcment of rotor flux position is done indirectly by computing the motor back...