BACKGROUND Being able to estimate (predict) the final spectrum of reflectance of a biomaterial, especially when the final color and appearance are fundamental for their clinical success (as is the case of dental resin composites), could be a very useful tool for the industrial development of these type of materials. The main objective of this study was the development of predictive models which...

OBJECTIVES Direct-filling resin composites are used in relatively small restorations and are not recommended for large restorations with severe occlusal-stresses. The aim of this study was to reinforce composites with fiber preforms, and to investigate the effects of layer thickness and configurations on composite properties. It was hypothesized that fiber preforms would significantly increase ...

The purpose of this study was to measure mass loss and surface roughness changes of different brands of flowable resin composites after a simulated toothbrushing test. The null hypotheses were that there would be no differences in mass loss and no significant changes in surface roughness after this test and that there would be no correlation between the two variables. The tested materials were ...

PURPOSE Aerosol deposition is a technology for coating ceramics with impact consolidation at room temperature. The aim of the present study was to investigate the thickness and the microstructure of the aluminium oxide layer on different three dental resin composite materials created by means of aerosol deposition. METHODS Disk-shaped specimens were fabricated with three resin composites (Est...

The aim of this study was to evaluate the effect of bleaching and thermocycling on microshear bond strength of bonded resin composites to enamel. Enamel slices were prepared from ninety-six intact human premolars and resin composite cylinders were bonded by using Adper Single Bond 2 + Filtek Z350 or Filtek silorane adhesive and resin composite. Each essential group was randomly subdivided to tw...

BACKGROUND Light-emitting diode (LED) curing lights offer advantages over quartz-tungsten-halogen (QTH) lights, but the first-generation LED lights had some disadvantages. PURPOSE This study compared a second-generation LED light with a QTH light to determine which was better at photopolymerizing a variety of resin composites. METHODS The ability of a LED light used for 20 and 40 seconds to...

This study aims at finding out if multiple attenuated internal reflection-infrared (MAIR-IR) spectroscopic analysis can be used as a tool to differentiate commercial resin composite brands and to find out if different resin composites will have different abilities of leaching materials that are cytotoxic to human gingival fibroblasts (HGFs) Tooth-colored resin fillings have become increasingly ...

INTRODUCTION JET-Fresh (Dentsply International, York, PA), a new airpolishing powder that contains aluminum trihydroxide as the abrasive agent, has been introduced for use with Prophy-Jet trade mark (Dentsply International). PURPOSE The aim of this study was to investigate the surface effects of aluminum trihydroxide airpolishing powder on a series of restorative materials. MATERIALS AND ME...

The objective of the study was to assess the effect of the cavity design factor (C-factor) on polymerization stress development (PSD) in resin composites. An experimental resin (BT resin) was prepared, which contained 2,2-bis[p-(2'hydroxy-3'-methacryloxypropoxy)phenylene]propane (B) and triethylene glycol dimethacrylate (T) in 1:1 mass ratio, and an activator for visible light polymerization. A...

Minimally invasive restorative techniques can be applied with direct resin composites. However, the preparation for an indirect restoration tends to lead to over-treatment of the tooth structures. A resin-coating technique has been proposed in which both a hybrid layer and a tight sealing film are produced on the dentin surface with a dentin adhesive system and a low viscosity micro-filled resi...