This study assessed the effects of hamstring prefatigue on peak torque, peak power, time to peak torque, knee angle of peak torque, and electromyography (EMG) activity of the hamstrings and quadriceps group during knee extensions at angular velocities of 60 degrees, 180 degrees, and 300 degrees.s(-1). Twenty Division I wrestlers performed 5 maximal knee extensions in prefatigued and nonfatigued...

A variable-speed, constant-pitch wind turbine was investigated to evaluate the feasibility of constraining its rotor speed and power output without the benefit of active aerodynamic control devices. A strategy was postulated to control rotational speed by specifying the demanded generator torque. By controlling rotor speed in relation to wind speed, the aerodynamic power extracted by the blades...

A novel shrouded wind-solar hybrid renewable energy and rain water harvester with an omni-directional-guide-vane (ODGV) for urban high-rise application is introduced. The ODGV surrounds the vertical axis wind turbine (VAWT) and enhances the VAWT performance by increasing the on-coming wind speed and guiding it to an optimum flow angle before it interacts with the rotor blades. An ODGV scaled mo...

Scaling laws are pervasive in biological systems, found in a large number of life processes, and across 27 orders of magnitude. Recent findings show both biological and engineered motors adhering to two fundamental regimes for the mass scaling of maximum force output. This scaling law is of particular interest for the robotics field as it can affect the design stage of a robot. In this study we...

This paper presents a flux-modulated direct drive (FMDD) motor. The key is to integrate the magnetic gear with the PM motor while removing the gear inner-rotor. Hence, the proposed FMDD motor can achieve the low-speed high-torque output and high-speed compact design requirements as well as high-torque density with a simple structure. The output power equation is analytically derived. By using f...

The paper applies the diagnosis method based on the analytic model by investigating the output waveforms of the currents, torque and speed specific to a PMSM driving system. Several faults are simulated: open phase, entire phase short circuit in two situations (with and without current measurement, short circuit before and after current sensor respectively) and current sensor fault (no reaction...

Ultrasonic motors are expected to be used as microactuators because of their high torque, low speed and simple construction. We have already reported cylindrical-shaped micro ultrasonic motors which utilized a lead zirconate titanate (PZT) thin film. In this paper, we discuss a micro ultrasonic motor composed of bulk PZT. The stator transducer had dimensions of 2.4 mm in diameter and 10 mm leng...

introduction: some clinicians use a handheld screw driver instead of a torque wrench to definitively tighten abutment screws. the aim of this study was to compare the removal torque of one-piece and two-piece abutments tightened with a handheld driver and a torque control ratchet. methods: 40 iti implants were placed in acrylic blocks and divided into 4 groups. in groups one and two, 10 iti one...

The objective of this study was to improve the reliability of the endurance test for the powertrain system of military tracked vehicles. The measurement system that measures the driving duty applied to the powertrain system caused by mobility on roads consists of eight analog channels and two pulse channels, including the propeller shaft output torques for the left and right sides. The data obt...

Isokinetic assessment of elite squash, tennis and track athletes confirms the accepted ratio of 60 to 80 per cent hamstring to quadriceps when testing at 90 deg-sec-1 for peak strength (torque). However, significant variations occur at higher test speeds up to 300 deg.sec-1 with the hamstrings becoming more prominent especially (p less than 0.001) in the nonpreferred (NP) leg. There was no sign...