Flame straightening is a common procedure used for repair work in steel components. It is based on heating a local region of the part by means of a flame torch. Due to the obstruction of the heat expansion, upsetting occurs in the work material. During cooling of the squashed zone shrinkage occurs and that is associated with tension forces which lead to the desired deformation. This process is ...

A new fully microwave-assisted liquid sample introduction system (MASIS) is presented and evaluated in Inductively Coupled Plasma Atomic Emission Spectrometry (ICP-AES). The device employs a single TM010 microwave cavity for the simultaneous aerosol generation and desolvation. The different experimental requirements of both physical processes demand a careful system design and a judicious selec...

In the most application of nozzle with gas-liquid two-phase flow, the quality of mixture in exhaust of nozzle is the most important parameter as well as the flow velocity. On the other hand, in some industrial application, such as water injection in forced induction (turbocharged or supercharged) internal combustion engine the spray quality is the main goal of designing. In this case and for im...

The nanoparticle transportation and Brownian diffusion in planar jet flow is simulated via large eddy simulation in this work. To thorough compare the Brownian diffusion with different particle size, we computed three particle diameter dp = 1 nm, 10 nm and 50 nm in one simulation process simultaneously. The numerical results showed that at the flow developing stage, the particle mass concentrat...

The radiation of sound from a perfectly expanded Mach 2.5 cold supersonic jet of 25.4 mm exit diameter flowing through a partially open rigid-walled duct with an upstream i-deflector has been studied experimentally. In the experiments, the nozzle is mounted vertically, with the nozzle exit plane at a height of 73 jet diameters above ground level. Relative to the nozzle exit plane (NEP), the loc...

Compressible gas flow inside a convergent-divergent nozzle and its exhaust plume atdifferent nozzle pressure ratios (NPR) have been numerically studied with severalturbulence models. The numerical results reveal that, the SST k–ω model give the bestresults compared with other models in time and accuracy. The effect of changes in value ofdivergence half-angle (ε ) on the nozzle performance, thru...

in this article, an algorithm for designing of a supersonic wind tunnel injection nozzle ejector is presented and based on this algorithm, a new ejector is designed for a supersonic wind tunnel. the injection nozzle consists of a volute, a nozzle, and several vanes. designed injection nozzle is simulated numerically, and the results are compared with the present injection nozzle. the results sh...

This report describes an experimental and numerical study of impinging, incompressible, axisymmetric, laminar jets, where the jet axis of symmetry is aligned normal to the wall. Particle Streak Velocimetry (PSV) is used to measure axial velocities along the centerline of the flow field. The jet-nozzle pressure drop is measured simultaneously and determines the Bernoulli velocity. The flowfield ...

Numerical simulations are performed to investigate the effects of ambient density (ρam) and nozzle diameter (Dnoz) on ignition characteristic diesel spray combustion under engine-like conditions. A total nine cases which consist different ρam 14.8, 30.0, 58.5 kg/m3 Dnoz 100, 180, 363 μm considered. The results show that predicted delay times in good agreement with measurements. current mixture ...