Redox conditions in magma oceans (MOs) have a key influence on the mass and composition of Earth’s early atmosphere. If the shallow part of the MO is oxidized, it may be overlain by an H2O–CO2 atmosphere, but if the near-surface magma is close to equilibrium with Fe-rich alloy, then the atmosphere will consist chiefly of H2, H2O, and CO, and on cooling will be rich in CH4. Although MOs are inti...

Metal-on-metal (MoM) bearings have become popular due to a major advantage over metal-on-polymer bearings for total hip arthroplasty in that the larger femoral head and hydrodynamic lubrication of the former reduce the rate of wear. However, concerns remain regarding adverse reactions to metal debris including metallosis caused by metal wear generated at the taper-head interface and another mod...

It is well-known that some metals/alloys are sensitizing on skin contact, but it is not so well appreciated that sensitization is dependent on the reaction of the metal/alloy with sweat. The first step in skin sensitization by metals/alloys is a corrosion process and the formation of soluble metal ions. The nature of this process has implications with respect to occurrence of metal contact derm...

Laser direct metal deposition is an advanced additive manufacturing technology suitably applicable in maintenance, repair, and overhaul of high-cost products, allowing for minimal distortion of the workpiece, reduced heat affected zones, and superior surface quality. Special interest is growing for the repair and coating of 2024 aluminum alloy parts, extensively utilized for a wide range of app...

in this paper, welding feasibility between aa1100, aa5050 and aa6082 aluminum alloys and a441 aisi steel by friction stir welding has been studied. mathematical analysis of the heat generation during process showed that the maximum temperature produced in aa6082 aluminum alloy and a441 aisi joint but heat distribution in aa1100 aluminum alloy was higher than the other alloys. the investigation ...

The effect of repeated repair welding, shielded with argon, on microstructural properties, corrosion resistance, and dry sliding wear behavior of aluminum alloy 5083/H116 were investigated. Samples were welded by metal inert gas welding method. 100% argon was used to protect fusion zone. Aluminum alloy 5356 was used as the filler metal. The samples for microstructure, corrosion, and wear tests ...

conclusions the castings fabricated from the ringless technique with non-precious alloy are acceptable. this investing system is useable for the fabrication of fixed restorations. results after statistical evaluation, the following results were obtained: the mean vertical margin discrepancy for conventional investing was 156.72 ± 64.67µ; for the ringless technique it was 117.3 ± 26.77µ; and for...

I thank Dr. Tony Pensak for his interest and comments on my article on gingival response to crowns.1,2 Dr. Pensak is suggesting that the poor gingival response of the 2 maxillary central incisors to the metalceramic crowns (Fig. 1) had more to do with the metallic content of these crowns than their marginal fit and contour. The literature is rich with evidence of longterm success and longevity ...

Nickel-metal hydride batteries (Ni-MH) are storers of electrochemical energy, which have a higher specific storage capacity than lead or nickel-cadmium batteries. The demand for Nickel-metal hydride batteries is increasing rapidly since their market launch in the early 1990's. Today there is no suitable and sustainable recycling process to recover nickel, cobalt and rare-earth metals. The disca...

Introduction: Metal prostheses in patients affect the radiotherapy dose distribution. Metal prostheses with high density and atomic number cause major changes in scattering and attenuation of radiation. The present study aims to assess the impact of metal knee prosthesis with various dimensions and materials on radiotherapy dose distribution. Material and Methods: In this research, the Varian L...