نتایج جستجو برای: intermetallic growth
تعداد نتایج: 821566 فیلتر نتایج به سال:
Single crystals of Pt2Ga17Ta3 were flux-grown in a high-temperature experiment from Pt-Ga mixture heated sealed tantalum crucible. Typical this intermetallic compound are hexagonal platelets. The stoichiometry the has been confirmed by energy-dispersive X-ray spectrometry (EDS) and its structure is determined single-crystal diffraction at room temperature. crystallizes new structural type, with...
In the present study, the transient liquid phase bonding of AISI 2205 dual phase stainless steel with amorphous BNi-3 interlayer was carried out. Based on the initial experimental and analytical studies, the parameters of temperature and bonding time were determined. In order to investigate the effect of bonding temperature on the microstructural changes of the joint, bonding was performed in t...
The Matthias rule, which is an empirical correlation between the superconducting transition temperature (Tc) and the average number of valence electrons per atom (n) in alloys and intermetallic compounds, has been used in the past as a guiding principle to search for new superconductors with higher Tc. The intermetallic compound SrBi3 (AuCu3 structure) exhibits a Tc of 5.6 K. An ab-initio elect...
The Government Accounting Office reports that the Department of Defense spends approximately $20 Billion per year on prevention and repair of corrosion. The resources required to combat corrosion problems are desperately needed for equipment and personnel in today's high operations tempo environment. Despite its significance, modeling for the spatial-temporal prediction of corrosion evolution h...
Replacing noble metals in heterogeneous catalysts by low-cost substitutes has driven scientific and industrial research for more than 100 years. Cheap and ubiquitous iron is especially desirable, because it does not bear potential health risks like, for example, nickel. To purify the ethylene feed for the production of polyethylene, the semi-hydrogenation of acetylene is applied (80 × 10(6) ton...
Investigation on Intermetallic Nickel Aluminides (Ni3Al) was carried to determine the suitability of this material to replace the existing automotive body. The purpose is to produce vehicles which are lighter, more fuel efficient and cause less pollution. One key technical design strategy for improving vehicles efficiency is the light weighting. Attractive properties of Ni3Al including low dens...
The microstructure, phase composition, and microhardness of both gas-atomized and mechanically milled powders of the Al7075 + 1 wt % Zr alloy were investigated. The gas-atomized powder exhibited a cellular microstructure (grain size of a few µm) with layers of intermetallic phases along the cell boundaries. Mechanical milling (400 revolutions per minute (RPM)/8 h) resulted in a grain size reduc...
نمودار تعداد نتایج جستجو در هر سال
با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید