The ability of plants to dynamically regulate water loss through stomata under conditions of changing evaporative demand or water availability is paramount for avoiding excessive desiccation, hydraulic failure, and plant death under conditions of water stress. Despite apparently similar functional demands on stomatal evolution, not all lineages employ the same mechanism of controlling water los...

the thermo-hydraulic behavior of the air flow over a two dimensional ribbed channel wasnumerically investigated in various rib-width ratio configurations (b/h=0.5-1.75) atdifferent reynolds numbers, ranging from 6000 to 18000. the capability of differentturbulence models, including standard k-ε, rng k-ε, standard k-ω, and sst k-ω, inpredicting the heat transfer rate was compared with the experi...

[1] Hydraulic tomography is a cost-effective technique for characterizing the heterogeneity of hydraulic parameters in the subsurface. During hydraulic tomography surveys a large number of hydraulic heads (i.e., aquifer responses) are collected from a series of pumping or injection tests in an aquifer. These responses are then used to interpret the spatial distribution of hydraulic parameters o...

INTRODUCTION: The calculation of Manning n values has been of interest since the Manning equation was presented in the late 1800s (Henderson, 1966). While estimation of n vahm for normal channels has been fairly well standardized, the estimation of n values in areas of dense vegetation continues to be subject to large variations depending on the experience of the engineer and the perceived dens...

with the expanding demand on application of magnesium alloys in automotive and aerospace industries, robust methods in fatigue characterization of commercially available magnesium alloys with high specific strength is anticipated. in this paper, rotating bending load controlled tests has been studied on specimens machined from an extrusion piece of az31b. due to asymmetric and anisotropic behav...

This paper presents a control system based on linear quadratic state feedback and state estimation for an hydraulic actuator with a exible mechanical load The purpose of the control system is to improve the dynamic properties by reducing the oscillatory behavior of the load and to eliminate the steady state error in the load position caused by external disturbances Using a simpli ed linear mode...

A concept of "Fractal Fracture Mechanics" for HDR .(Hot Dry Rock) geothermal reservoir design has been developed as an extension of conventional rock fracture mechanics. It is suggested that this concept is successfully applicable to characterize and model subsurface fracture network in HDR geothermal reservoir. Furthermore, this modeling procedure makes it possible to evaluate the thermal ener...

Operational failures in centrifuge pumps could be hydraulic or mechanical. However, most of these mechanical and hydraulic failures are connected cause of their operational nature and finding the right cause is due to considering numerous mechanical and hydraulic signs and parameters in pumps. On the other hand, due to non-linear and fluctuant behavior of pumps in the matter of time and not pre...