In this paper conjugated heat transfer in thermal entrance region through the sinusoidal wavy channel has been investigated. The fluid flow is assumed to be laminar, steady state, incompressible, and hydrodynamically fully developed. A constant heat flux is assumed to be applied on the outer edge of the channel wall. In this study the governing equations including continuity, momentum and energ...

Experimental studies and numerical simulation of growth and lift-off processes of single bubbles formed on designed nucleation sites have been conducted under low-gravity conditions. Merging of multiple bubbles and lift-off processes during boiling of water in the parabola flights of KC-135 aircraft were also experimentally studied. The heating area of the flat heater surface was discretized an...

An experimental study was carried out to investigate the effects of inlet pressure, sample thickness, initial sample temperature, and temperature sensor location on the surface heat flux, surface temperature, and surface ultrafast cooling rate using stainless steel samples of diameter 27 mm and thickness (mm) 8.5, 13, 17.5, and 22, respectively. Inlet pressure was varied from 0.2 MPa to 1.8 MPa...

Dissipation and flux-variance methods, derived from the turbulent kinetic energy and temperature variance budget equations in conjunction with Monin-Obukov similarity theory, were used to estimate surface fluxes of momentum and sensible heat. To examine the performance of these two methods, direct eddy correlation measurements were carried out above a nonuniform grass-covered forest clearing in...

Pool boiling enhancement through surface modification has garnered the attention of many researchers for extending the limits of heat flux dissipation. Simulated copper chips were used in a pool boiling setup with water boiling at atmospheric pressure. Heat transfer performance of different microchanneled surfaces was compared to that of a plain surface. The results of the study showed that the...

We report a novel boiling heat transfer (NBHT) in reduced graphene oxide (RGO) suspended in water (RGO colloid) near critical heat flux (CHF), which is traditionally the dangerous limitation of nucleate boiling heat transfer because of heater failure. When the heat flux reaches the maximum value (CHF) in RGO colloid pool boiling, the wall temperature increases gradually and slowly with an almos...

in this study, mixed convection heat transfer and local and global entropy generation in aventilated square cavity have been investigated numerically. the natural convection effect isachieved by a constant heat flux imposed at the bottom wall and cooled by injecting a coldfollow. in order to investigate the effect of port location, four different placementconfigurations of the inlet and outlet ...

The evaporation heat transfer and pressure drop characteristics of HFC-161 in a horizontal smooth tube with an inside diameter of 9 mm was experimentally investigated. The local heat transfer coefficient and total pressure drop were measured at the heat flux ranging from 15 – 25 kW/m, the mass flux ranging from 100 – 200 kg/(m·s), and the evaporation temperature of 5, 10 °C. The experimental re...

Pool boiling experiments were conducted with three horizontal, flat, silicon surfaces, two of which were coated with vertically aligned multiwalled carbon nanotubes (MWCNTs). The two wafers were coated with MWCNT of two different thicknesses: 9 m (Type-A) and 25 m (Type-B). Experiments were conducted for the nucleate boiling and film boiling regimes for saturated and subcooled conditions with l...

Heat transfer with liquid–vapor phase change in microchannels can support very high heat fluxes for use in applications such as the thermal management of high-performance electronics. However, the effects of channel cross-sectional dimensions on the two-phase heat transfer coefficient and pressure drop have not been investigated extensively. In the present work, experiments are conducted to inv...