نتایج جستجو برای: electro slag remelting esr

تعداد نتایج: 36075  

2013
Ediga Anjaneyulu Mopuri Ramgopal Golla Narasimha Meriga Balaji

The effect of pig iron slag particles on soil physico-chemical, biological and certain soil enzyme properties was studied. Contamination of iron slag particles altered physico-chemical, biological and enzyme properties of soil. While soil pH increased slightly, electrical conductivity, carbon, potassium and phosphorus contents increased significantly in polluted soil. Contamination of soil with...

2001
Ilya N. Bindeman John W. Valley J. L. Wooden Harold M. Persing

The Yellowstone Plateau volcanic field, the site of some of the largest known silicic volcanic eruptions, is the present location of NE-migrating hotspot volcanic activity. Most volcanic rocks in the Yellowstone caldera (0.6 Ma), which formed in response to the climactic eruption of 1000 km3 of Lava Creek Tuff (LCT), have unusually low oxygen isotope ratios. Ion microprobe analysis of both U^Pb...

2006

smelting of hammerable iron and its treatment in antiquity and Medieval produced also by-product: slag. Because of small yields of iron the process produced only small amounts of slag that did not attract attention of smelters concerning its possible use. the use of slag pieces was only accidental. a lot of slag pieces and blocks from slag pit shaft furnaces were used as a material for mound bu...

2015
Yibo HE Biao TANG Qiang LI

Alumina-rich iron ore is a widely existed polymetallic deposit in the nature, and it has a high comprehensive utilization value. Because the alumina and iron contents of alumina-rich iron ore vary from each other, there are many different measures and processes to recover iron and alumina from the various kinds of alumina-rich iron ore. In the blast furnace (BF) ironmaking process, the alumina ...

2012
Ch. Ramesh N. Jeevan Kumar Anil Kumar

–The objective of present work is to use this industrial waste i.e. Slag as particulate filler material to the epoxy matrix composites by molding technique with different weight fractions ( 0%, 5%,10%,15%, 20% ) to study the mechanical behaviour of reinforced polymer composite material. The change in weight is studied for Slag under different tests like, tensile, bending and impact for obtainin...

2013
Ediga Anjaneyulu Mopuri Ramgopal Golla Narasimha Meriga Balaji

(Received: November 27, 2010; Accepted: February 9, 2011) Abstract: The effect of pig iron slag particles on soil physico-chemical, biological and certain soil enzyme properties was studied. Contamination of iron slag particles altered physico-chemical, biological and enzyme properties of soil. While soil pH increased slightly, electrical conductivity, carbon, potassium and phosphorus contents ...

2007

The surface tensions of a number of common commercial ferroalloys have been measured during their granulation in water. These measured values are significantly lower than would be expected from a normal metal-gas interface and are more typical of the interfacial tensions of slag-gas interfaces. This would seem to indicate that the slag-metal interface on the surface of a granule produces no sig...

2017
Xuefeng She Zhuo Zhang

In this study, ZnFe2O4 (ZFO) nanotapers are fabricated on the ZnO nanorods (NRs) by recycling rare-earth oxide (REO) slag as the iron source, which thereby exhibits dramatically enhanced photoelectrochemical (PEC) efficiency. Our studies demonstrate that the electron-hole separation and charge migration can be facilitated by the cascade band alignment of ZFO and ZnO and the branched nanotaper s...

2010
J. Stjernberg B. Lindblom J. Wikström Magnus Odén

Two types of refractory bricks were used in reaction tests with slag from a production kiln for iron ore pellet production. Electron microscopy was used to characterize morphological changes at the slag/brick interface and active chemical reactions. Phases such as kalsilite, nepheline and potassium β-alumina form, in a layered structure, as a consequence of alkali metals migration in the brick....

2017
R. Khanna V. Sahajwalla

Refractories, materials that can withstand high temperatures, play an important role in the iron and steel sector which alone accounts for ~70% of total refractories pro‐ duced. In this chapter, detailed wettability and interfacial phenomena investiga‐ tions on alumina-carbon and zirconia-carbon refractories at steelmaking temperatures. The wettability between refractory substrates and molten i...

نمودار تعداد نتایج جستجو در هر سال

با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید