Al-Si-based casting alloys have a great potential in various industrial applications. Common strengthening strategies on these alloys are accompanied inevitably by sacrifice of ductility, known as strength-ductility trade-off dilemma. Here, we report a simple route by combining rapid solidification (RS) with a post-solidification heat treatment (PHT), i.e. a RS + PHT route, to break through thi...

Recently, steel fibre reinforced polymers (SFRP) sheets have been introduced for the repair and rehabilitation of concrete structures. Few researchers studied the behaviour of the concrete columns wrapped with SFRP sheets; however, several critical parameters such as the cost and ductility effectiveness of the SFRP wrapped concrete columns have been lightly addressed. Thus, the main objective o...

Current concrete technology has made higher concrete grades more affordable to mid and high-rise buildings; hence its use has been increasing in the late years as it allows for smaller cross-sections, reduction of the structure’s weight, improve durability, among other benefits. However, it is known that brittleness of plain concrete increases with the strength; therefore, some national codes h...

Microstructure evolutions and mechanical properties of a commercially pure titanium (CP-Ti, grade 2) during multi-pass rotary-die equal-channel angular pressing (RD-ECAP) and cold rolling (CR) were systematically investigated in this work, to achieve comprehensive property for faster industrial applications. The obtained results showed that the grain size of CP-Ti decreased from 80 μm of as-rec...

In order to calculate the flexural strength of normal-strength concrete (NSC) beams, the nonlinear actual concrete stress distribution within the compression zone is normally replaced by an equivalent rectangular stress block, with two coefficients of α and β to regulate the intensity and depth of the equivalent stress respectively. For NSC beams design, α and β are usually assumed constant as ...

It follows from the Chapter 7 that, except for very short gauge lengths, percent elongation is mainly influenced by uniform elongation, and is thus dependent upon the strain-hardening capacity of the matrix. In contrast, reduction in area is more a measure of the deformation required to produce fracture, and its chief contribution arises from the necking process. The work of Groom (1971) illust...

Effectiveness of a second phase in metallic glass heterostructures to improve mechanical properties varies widely. Unfortunately, methods to fabricate such heterostructures like foams and composites do not allow controlled variation of structural features. Here we report a novel strategy, which allows us to vary heterostructural features independently, thereby enabling a systematic and quantita...

The objective of this paper is to provide a review of the Direct Strength Method for coldformed steel design. The Direct Strength Method was formally adopted in North American design specifications in 2004 as an alternative to the traditional Effective Width Method. The appendix of this paper provides an excerpt from the North American Specification which provides the Direct Strength Method equ...

Semisolid state processing is a methodology that transforms dendritic as-cast microstructure into globular non-dendritic with optimized mechanical properties. Rheocasting process involves mechanically stirring metals in semisolid and its benefits are associated parameters. In order to evaluate time effects, magnesium alloy MRI 230D (Mg–Al6.45–Ca2.25–Mn0.27–Sr0.25–Sn0.84) was melted cooled down ...