In this paper, the bandwidth enhancement of TIA amplifier can be design for achieving the high information capacity which is used in optical fiber communication for existing transimpedance amplifiers in CMOS technology. The proposed TIA amplifier also trade-offs between gain, bandwidth, noise, and group delay variation with introduce on differential architecture along an RGC network as input an...

At receiving front end, the low noise amplifier design, being the first building block to receive the signal puts a tremendous challenge on modern day radio frequency engineers to meet real world problems involving trade-off in design issues. In this paper the recent trends for noise figure are streamlined in concurrence to Ultra Wide Band (UWB) radio transmission spectrum. A comparative study ...

This paper describes the design of a power amplifier (PA) for 802.11n WLAN fabricated in 65nm CMOS technology. The PA utilizes 3.3V thick gate oxide (5.2nm) transistors and a twostage differential configuration with integrated transformers for input and interstage matching. A methodology used to extract the layout parasitics from electromagnetic (EM) simulations is described. For a 72.2Mbit/s, ...

Some new active Voltage Controlled RC integrator and differentiator circuit realizations, with both single and differential input capabilities, using a few passive components and a current feedback amplifier (CFA) device, are proposed. A multiplier (ICL 8013) element has been appropriately utilized in the feed forward / feedback connection to obtain electronic tuning of the time constant (τo) b...

The design of a new single stage class AB operational amplifier is presented. Amplifier incorporates an input differential pair with minimum current selector and common-mode feedback to control the tail current. It shows small-signal behavior of a simple OTA, while class AB feedback provides high slew rate when large input signals are applied. Prototype circuit was manufactured in 2pm analog CM...

This paper presents a switched-capacitor (SC) band-pass biquad using a simple quasi-unity gain amplifier. In sub-nanometer CMOS technologies the intrinsic gain of the transistors is low; this increases the difficulty of designing high gain amplifiers. The proposed SC filter is based on the Sallen-Key biquad and it requires only a simple low gain amplifier. A differential filter circuit, includi...

The Operational Amplifier (Op-Amp) is a fundamental building block in Mixed Signal design. Two stage Op-Amp is one of the most commonly used Op-Amp architectures. In this paper an operational amplifier by CMOS is presented whose input depends on bias current which is 30uA and designed using 1 um technology. In sub-threshold region due to unique behaviour of the MOS transistors not only allows a...

A large dynamic-range Variable Gain Amplifier (VGA) suitable for Ultra Wide Band (UWB) applications is presented. The VGA is composed of three programmable variable gain amplifier stages followed by an output buffer. Such wide bandwidth allows our proposed VGA to be used in multi-standard protocols. Power reduction is developed for the variable gain amplifier stages. Thorough analyses of the mi...

Based on a theoretical erbium-doped fiber amplifier (EDFA) model, we have proposed an application of disturbance observer(DOB) with proportional/integral/differential(PID) controller to EDFA for minimizing gain-transient time of wavelength -division-multiplexing (WDM) multi channels in optical amplifier in channel add/drop networks. We have dramatically reduced the gain-transient time to less t...

The compression wave cochlear amplifier (CW-CA) model is introduced for the first time. This is the first cochlear amplifier model that is soundly based on the physiology of the inner ear and neural centres. The CW-CA, which is assumed to be driven by the basilar travelling wave (TW), includes outer hair cell (OHC) motility and neural signal transmissions between the hair cells and the central ...