AIM To compare the average sealer cement film thickness and the extent and pattern of sealer penetration into dentinal tubules in association with four obturation techniques in curved root canals. METHODOLOGY Mesial canals of 44 extracted mandibular molars were randomly divided among the SimpliFill, continuous wave, Thermafil and 0.04 matched taper (master cones) lateral compaction obturation...

OBJECTIVE To assess the strength of the evidence describing the effectiveness of alternative strategies to the detection and management of early occlusal caries and suspected occlusal dentinal caries. METHODS Nine detection and intervention decision points were identified as being central to the management of early occlusal caries and suspected occlusal dentinal caries, or suspicious areas. F...

introduction:  the aim of this in-vitro study was the evaluation of mperature changes due to irradiation of two different lasers used for the reduction of dentinal hypersensitivity and their effect on the pulp damage. the study was done for two dentin thicknesses.  methods:  twenty intact extracted third molars were prepared by longitudinal ground sectioning for 1 and 2 mm dentin thicknesses wh...

We present a combined novel methodology to study the three-dimensional complex geometry of a tortuous crack and identify the essential features of the crack and its propagation inside a heterogeneous material. We find that some severe damage events occur unexpectedly below a local mode-I crack within the sample; we realize that the severe plastic zone of the local mode-I crack is shifted down b...

This paper investigates the phenomenon of slant fracture observed in stable tearing tests of many ductile materials, where an initially flat crack, loaded under remote Mode I conditions, tends to grow into a slant crack and stay in the slant configuration until final fracture. In an effort to identify potential reasons why cracks prefer to grow in a slant manner, three-dimensional finite elemen...

initial cracks occur in high strength concrete sleepers for various reasons, such as shrinkage and wrong curing and long lifetime of over 50 years of sleepers. these cracks may lead to complete failure of the structure. in order to more accurately design the sleepers, fracture mechanics (not strength of materials) should be incorporated. in order to achieve this purpose, it is important to fore...

Although, experimental studies have reported fracture at the corner of Steel Plate Shear Walls (SPSW), no study has been performed to investigate the crack effect, yet. Therefore, in this paper, the effect of crack at the corner of SPSWs on the seismic behavior of the system was investigated. Two probable cracks, that have been studies at the corner of SPSWs utilizing extended Finite Element me...