This paper presents a modified two level inverter topology to improve the low speed performance of the direct torque controlled (DTC) three phase induction motor drive. Proposed method is based on current ripple principle. In this technique, the inverter switching states are derived as a function of rotor speed. This method gives low ripple in flux and torque at low speed operation when compare...

A soft-switching inverter topology (the Class Φ) is presented which draws dc source current through a transmission line or a lumped-network approximation of a distributed line. By aligning the inverter switching frequency just below the line’s λ/4-wave resonance, the Class Φ topology enforces oddand even-harmonic content in its drain voltage and input current, respectively. The symmetrizing act...

Hysteresis current control method is vastly used in PWM inverters because of simplicity in performance, fast control response and good ability in limiting peak current. However, switching frequency in hysteresis current control method with fixed bandwidth has large variation during a cycle and therefore causes non-optimal current ripple generation in output current. One of basic problems in imp...

Renewable energy sources can be used for electric power generation to supply specific devices in distributed systems such as smart grids. Hydrogen fuel cells have proven to be an effective solution to produce electrical energy with fairly good efficiency and minimum environmental pollution. A single-stage solution to interconnect a fuel cell with a low-voltage distribution system is proposed in...

This paper explores Switched Inductor (SL) Quasi Z-source Inverter which has high boost factor and performance when compared to other Z-Source inverters along with three control methods: simple boost, maximum boost and maximum constant boost. The proposed inverter improves the input current, reduces the passive count and also the reliability. The simulations are done in MATLAB/Simulink environm...

1,2 Electrical and Electronics Engineering, Sree Buddha College Of Engineering Abstract—This paper highlights the performance of a five level inverter fed ac drive system. The presence of harmonics in the output voltage and current waveforms of traditional voltage source inverter (VSI) causes significant amount of energy loss. Multilevel inverters can reduce this harmonic content in the output ...

This paper describes a multilevel Z-source inverter for solar photovoltaic applications. The conventional power conversion topology performs either buck or boost the input voltage for non linear load depending upon duty ratio and modulation index in a multiple stage conversion with the help of impedance source passive network (L and C), which is usually known as Z-Source, which couples the n le...

Abstract: This paper presents a seamless transition method for a droop-controlled inverter. The droop control is suitable to make the inverter work as a voltage source in both islanded and grid-connected modes, however, the transfer between theses modes can result in a big inrush current that may damage the system. The proposed method allows the droop-controlled inverter to improve the transien...

6.1 INTRODUCTION The previous chapters have discussed the development of the MPPT algorithm and the control of the DC-DC converter in a standalone PV system. A grid-connected PV system is composed of a photovoltaic array, DC-DC converter, DC link capacitor, single phase DC-AC inverter, filter inductor, power grid, and non-linear load. The grid interconnection of a PV power generation system has...

decentralized control strategies are popular candidates in microgrids control because of their reliability and performance. conventionally, droop control (as a main decentralized strategy) is been utilized in order to prevent permanent droop of voltage and frequency after change in loads and also to share generated power between distributed generation units. in this paper, a new droop control s...