In tensile tests, ?-Mg/C14–Mg2Ca eutectic alloy with a lamellar structure is plastically deformed above 473 K but ruptures before yielding at temperatures below 423 K. This study investigates the effect of ?/C14 interface on creep strength under 40 MPa stress. The curves exhibited three stages: normal transient stage, minimum creep-rate and accelerating stage. rate was proportional to spacing, ...

The stacking life of corrugated containers under load decreases as relative humidity (RH) increases and when RH cycles, compared with when RH remains stable. Conventional RH test schedules that rely on fixed cycle periods do not adequately reflect the significance of moisture diffusion and hygroexpansion rate phenomena on the creep of corrugated containers and general wood fiber products. With ...

Creep deformation and rupture experiments are conducted on samples of the Ni-base superalloy directionally solidified GTD-111 tested at temperatures between 649°C and 982°C and two orientations (longitudinally and transversely oriented). The secondary creep constants are analytically determined from creep deformation experiments. The classical Kachanov–Rabotnov model for tertiary creep damage i...

This paper characterized bovine extraocular muscles (EOMs) using creep, which represents long-term stretching induced by a constant force. After preliminary optimization of testing conditions, 20 fresh EOM samples were subjected to four different loading rates of 1.67, 3.33, 8.33, and 16.67%/s, after which creep was observed for 1,500 s. A published quasilinear viscoelastic (QLV) relaxation fun...

The creep behavior of bagasse-based composites with virgin and recycled polyvinyl chloride (B/PVC) and high density polyethylene (B/HDPE) as well as a commercial wood and HDPE composite decking material was investigated. The instantaneous deformation and creep rate of all composites at the same loading level increased at higher temperatures. At a constant load level, B/PVC composites had better...

Long term tensile creep studies were conducted on binary NiAl in the temperature range 700-1200 K with the objectives of characterizing and understanding the creep mechanisms. Inverse and normal primary creep curves were observed depending on stress and temperature. It is concluded that the primary creep of NiAl is limited by dislocation mobility. The stress exponent for creep, n, decreased fro...

Polypropylene is one of the most common, fastest growing and versatile thermoplastics currently used to produce tanks and chemical piping systems. Even at room temperature creep is considerable for polypropylene products. The creep behavior of strains, stresses, and displacement rates is investigated in a thick-walled cylinder made of polypropylene reinforced by functionally graded (FG) multi-w...

Nanoclays are new generation of processed clays of interest in a wide range of high performance composites. In other words, nanoclay is defined as a clay that can be modified to make the clay complexes compatible with organic monomers and polymers. Here, it can be said that the polymeric nanocomposites are among the most exciting and promising classes of materials discovered recently. A number ...

This study was conducted with grazing nursing calves (197 kg) to determine the effects of 1) limiting creep feed intake and 2) increasing the concentration of ruminal escape CP in creep feed at a limited level of creep feed intake on fescue and milk intake, ruminal NDF digestion, and total tract digestibility in calves fed high-quality, freshly harvested fescue. The treatments were 1) control (...

A micromechanical finite element (FE) framework was developed to predict the viscoelastic properties (complex modulus and creep stiffness) of the asphalt mixtures. The two-dimensional (2D) microstructure of an asphalt mixture was obtained from the scanned image. In the mixture microstructure, irregular aggregates and sand mastic were divided into different subdomains. The FE mesh was generated ...