Objective. This study evaluated the effect of immediate or delayed finishing/polishing using different systems on the surface roughness, hardness, and microleakage of a silorane-based composite. Material and Methods. Specimens were made with silorane-based composite (Filtek P90, 3M ESPE) and assigned to the treatments: control (light-cured); aluminum oxide discs (Sof-Lex, 3M ESPE); diamond-impr...

A method is described for the fabrication of a closed hollow bulb obturator prosthesis using a hard thermoforming splint material and heat-cured acrylic resin. The technique allowed the thickness of the thermoformed bulb to be optimized for weight reduction, while the autopolymerized seal area was covered in heat-cured acrylic resin, thus eliminating potential leakage and discoloration. This te...

Mechanical behaviour of unsaturated polyester resin used for the composite materials has been studied to determine various important parameters, such as tensile and compressive, single edge-notch tensile fracture toughness, flexural properties and fracture energy. Fracture toughness, KIC, and fracture energy, GIC, obtained for the polyester resin lie between the typical values for epoxy resins ...

This article presents new modifications to the clinical technique of fabricating directly applied resin-bonded fibre-reinforced bridges. Torsional and flexural strength is achieved by means of a reinforced polyethylene fibre ribbon substructure surrounded by laminated layers of microhybrid and microfilled resins. The modifications provide a simple method for creating a better pontic-ridge relat...

BACKGROUND Although bonding to denture teeth after surface treatment with chemical agents is desirable, there is little information on the use of Visible Light Cure composite resin (VLC) as bonding denture materials. OBJECTIVES To determine the effect of various surface treatments on shear bond strength between Visible Light Cure composite resin and the acrylic denture teeth interface. METH...

OBJECTIVES To use the FT-Raman spectroscopy for evaluation the degree of polymerization of dental composite as a result of photo curing with a new light source in comparison to the conventional halogen light. MATERIALS AND METHODS In this study a new light source, based on a metal-halide lamp (TOPSPOT G12) was developed at NRC-Egypt for curing dental composites. Two groups of 108 composite sa...

In this paper, we report a novel method for fabricating ion-selective membranes in poly(dimethylsiloxane) (PDMS)/glass-based microfluidic preconcentrators. Based on the concept of capillary valves, this fabrication method involves filling a lithographically patterned junction between two microchannels with an ion-selective material such as Nafion resin; subsequent curing results in a high aspec...

Tenax-resin has been originally developed for grabbing volatile organic compounds from gases. The resin is a porous polymer (2,6-diphenyl-p-phenylene oxide) and it has low affinity for water (floats on the surface). It has high affinity for hydrophobic organic contaminants (HOCs), thus capturing them efficiently from water. On the other hand, the HOCs can be quite easily be extracted from Tenax...

By utilizing ultrasonic annealing at a temperature below (or near) the glass transition temperature Tg, we revealed a microstructural pattern of a partially crystallized Pd-based metallic glass with a high-resolution electron microscopy. On the basis of the observed microstructure, we inferred a plausible microstructural model of fragile metallic glasses composed of strongly bonded regions surr...

To date, treating vertical food impaction with open contact effectively, especially with an atraumatic therapy, remains a challenge. In this study, we developed a simple, atraumatic, and economic therapeutic measure to treat vertical food impaction. The scientific rationale of our therapeutic technique is to restore an intact and firm proximal contact with proper location and form relationships...