In order to improve the yield of BN nanotubes prepared by ball milling annealing method, a small amount magnesium was used as catalyst synthesized boron nitride nanotubes. The results showed that with high yield, purity and uniform size were synthesized. morphology BNNTs is bamboo-like cylinder-shaped. diameter them about 50 150 nm most are 100nm. length dozens microns. existence end particles ...

The capture efficiency of the small aerosol particle is strongly influenced by the structure of fibrous layers. This study presents particle deposition and dendrite formation on different arrangements of binary fibers. 2-D numerical simulation is performed using the open source software of OpenFOAM. In the instantaneous filtration of a single fiber, obtained results are in good agreement with th...

However, problems such as osteoporosis due to high elasticity of metals relative to bones, and local infections and systemic problems caused by releasing metallic ions have motivated research on replacing metallic screws with non metallic ones. In this study, the composite containing poly-l-lactic acid and bioactive glass fibers were considered for the design of the screw using ABAQUS software ...

introduction: today, have been approved scientifically relationship between presence of asbestos fibers in the human respiratory area and malignant diseases such as lung advanced fibrosis (asbestosis), gastrointestinal, lung and laryngeal cancers. the aim of this study was the determination of asbestos fibers concentration in yazd city’s air in the summer of 2015. methods: this is a descriptive...

Single-wall boron nitride nanotubes samples synthesized by laser vaporization of a hexagonal BN target under a nitrogen atmosphere are studied by UV and visible Raman spectroscopy. We show that resonant conditions are necessary for investigating phonon modes of BNNTs. Raman excitation in the UV (229 nm) provides preresonant conditions, allowing the identification of the A1 tangential mode at 13...

In this work, raw fibers of a local species of stabraq (milkweed) were scoured, bleached and blended with cotton fibers with a ratio of 75/25 (cotton/stabraq). The improved stabraq fibers, scoured and bleached cotton and the blended fibers were spun into fine yarns and then they were subjected to dyeing with two types of reactive dyes namely, cold brand and high exhaustion brand reactive dye at...

abstract introduction: interferential current is one of the most popular kinds of electrical stimulation that are used in electrotherapy. despite its clinical popularity, there have been limited studies to investigate how this stimulation protocol affects the nerve fibers. this study was aimed to develop a realistic model for the stimulation of nerve fibers by interferential currents and using ...

in this study, the strain rate effect on the bending properties of fiber reinforced composites for three types of polymer composites namely phenolic resin reinforced by woven basalt fibers, woven carbon fibers, and woven basalt/ woven carbon fibers at a total volume fraction of approximately 35% has been determined. flexural tests have been conducted at low range of strain rates included 0.03 m...

color match between fiber-reinforced composite (frc) restorations and teeth is an imperative factor in esthetic dentistry. the purpose of this study is to evaluate the influence of veneering composites and fibers on the color change of frc restorations.glass and polyethylene fibers were used to reinforce a direct microhybrid composite (z250, 3m espe) and a microfilled composite (gradia indirect...