The deep cryogenic treatment is a complementary operation that is done on a variety of tool steels aimed at improving their abrasion resistance and hardness. In the case of the H13 hot-work steel, which is widely used at high temperatures as a hot-deformation tool, we need to determine the efficiency of subzero treatment on it at the working temperature. In this regard, this paper is focu...

The wear of cental amalgam was studied by single- and double-pass sliding and by a silicon carbide abrasion test. A dispersed amalgam showed significantly better resistance to two-body abrasion than the spherical amalgams tested. The wear amalgam was determined by resistance to penetration and by a ductile mode of surface failure over the load range studied. Differences in the wear of amalgam a...

bioactive glass air abrasion is a conservative technique to remove initial decalcified tissue and caries. this study examined the shear bond strength of composite resin to sound and decalcified enamel air-abraded by bioactive glass (bag) or alumina using etch-and-rinse and self-etch adhesives.forty-eight permanent molars were root-amputated and sectioned mesiodistally. the obtained 96 specimens...

This study explored the mechanisms by which crevices act as refugia for small algae during abrasive disturbances. Four substrates with different crevice features were subjected to three levels of abrasion in a stream-based experiment. Substrates were sand-grain caddisfly cases and three glass rod substrates that mimicked caddisfly cases in size and shape, as well as forming a gradient of larger...

This paper describes the results of room temperature joining of TiO2 / SiO2 IRF by sputter deposition with a special emphasis of improvement of adherence at the interface. This multilayer system is designed to shield the infrared energy of solar spectrum by interference reflection. The abrasion resistance of the multilayer stacks was also estimated by the Haze value after the Taber abrasion tes...

This paper describes an in-depth evaluation of an abrasion testing procedure for concrete pavers developed in Australia The test involves abrasion of the paver surface by a rapidly rotating ball race under load. Water is used both to lubricate the race and to remove debris. The investigation included the study of factors affecting the test results such as the load applied to the ball-race, the ...

The purpose of this study was to evaluate the influence of air-abrasion and subsequent heat treatment on the shear bond strength of the bond between indirect composites and a zirconia material. Four surface preparations were employed; ground flat, then heated to regenerate the crystal phase (C); air-abraded with alumina for 10 s (S10), for 20 s (S20), and air-abraded for 10 s and heated (H). Di...

BACKGROUND Pulp stone, though of an unclear aetiology, is clinically common. It potentially poses procedural difficulty to the endodontist and may also be a marker of an underlying systemic condition. OBJECTIVES The study investigated pulp stone occurrence in adult restorative patients. It also highlighted the relationship between pulp stone and pristine posterior teeth, chronic periodontitis...

AIM The aim of this in vitro study was to evaluate the shear bond strength of a one-step self-etch adhesive to dentin pretreated with phosphoric acid, air abrasion, or laser. METHODS AND MATERIALS Fifty-six extracted non-carious human mandibular molars were mounted and the occlusal surfaces ground with a mechanical grinder to obtain flat occlusal dentin surfaces. The teeth were randomly divid...